User manual AEG-ELECTROLUX ESL 64085

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual AEG-ELECTROLUX ESL 64085. We hope that this AEG-ELECTROLUX ESL 64085 user guide will be useful to you.


AEG-ELECTROLUX ESL 64085 : Download the complete user guide (5497 Ko)

You may also download the following manuals related to this product:

   AEG-ELECTROLUX ESL64085R (5497 ko)

Manual abstract: user guide AEG-ELECTROLUX ESL 64085

Detailed instructions for use are in the User's Guide.

[. . . ] ⷠDo not keep the appliance door open without supervision. Do not use the appliance for other uses to prevent injury to persons and damage to property. ⷠOnly use the appliance to clean accessories that are applicable for dishwashers. ⷠDo not put flammable products or items that are wet with flammable products in, near or on the appliance. [. . . ] Make sure not to squash or cause damage to the mains plug and cable behind the appliance. ⷠMake sure that there is access to the mains plug after the installation. ⷠWhen the washing programme is completed , a green visual signal shows on the floor below the appliance door. ⷠWhen the appliance has a malfunction, a red visual signal flashes on the floor below the appliance door. When the washing programme starts, a red visual signal shows on the floor below To operate with the controls, keep the appliance door ajar. 1) After you fill the container, the salt indicator can stay on for some hours. This does not have an unwanted effect on the operation of the appliance. 1) When the salt container and/or the rinse aid dispenser are empty, the related indicators do not come on while a washing programme operates. After ten minutes from the end of the washing programme, the Auto Off function automatically deactivates the appliance. DELAY BUTTON Press this button again and again to delay the start of the washing programme from 1 to 24 hours. FUNCTION BUTTONS With these buttons you can: · SETTING MODE The appliance must be in setting mode for these operations: · Only one programme indicator comes on. ­ It is necessary to cancel the programme or the delay start to go back to the setting mode. ACOUSTIC SIGNALS You can hear the acoustic signals in these conditions: · To activate the acoustic signals again, do steps (1) through (7). Be sure that the set level of the water softener agrees with the water hardness in your area. If you use the combi detergent tablets ('3 in 1', '4 in 1', '5 in 1'), use the multitab function (refer to 'Multitab function'). Adjust the level of the water softener if this does not agree with the water hardness in your area. Contact your local water authority to know the water hardness in your area. The display shows the setting of the and you water softener (example: hear five acoustic signals = level 5). Fill the salt container with 1 litre of water (only for the first time you fill with salt). It is correct that water comes out from the salt container when you fill it with salt. If you use the detergent tablets, put the tablet in the detergent dispenser 1 . These cannot fully dissolve with short washing programmes and can decrease the washing results. [. . . ] Make sure that an incorrect position of the items do not cause the blockage of the spray arms. Make sure that the filters are clean and correctly assembled and installed. There are streaks, whitish stains, or a bluish layer on glasses and dishes. The washing programme was without a drying phase or with a decreased drying phase. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE AEG-ELECTROLUX ESL 64085




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual AEG-ELECTROLUX ESL 64085 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.