User manual AEG-ELECTROLUX ESL6251

[. . . ] D i s h w a s h e r User information ESL 6251 822 612 669-00-300905-03 g Dear Customer, Please read these user instructions carefully and keep them to refer to later. Please pass the user instructions on to any future owner of the appliance. The following symbols are used in the text: 1 Safety instructions 3 Useful tips and hints 2 Environmental information Warning!Notes that show how to avoid damage to the appliance. 2 Contents Operating Instructions . 4 4 5 5 7 7 9 10 12 13 13 16 17 18 19 21 22 22 23 26 26 28 29 30 31 32 32 33 34 36 38 39 Installation and connection instructions. [. . . ] · Dishes dry more quickly if you open the door for a moment after the cycle has ended and then leave it slightly open. 2. Turn off the water tap. To change a dishwashing cycle As long as the cycle has not yet started, you can still change the dishwashing cycle. First cancel the dishwashing cycle, then re-set the time delay, lastly select the new dishwashing cycle. Removing the Dishes 3 It is normal for the inner door and the dispensers to be damp. This way you avoid dripping water from the upper basket onto dishes in the lower basket. 22 Care and cleaning 1 Do not use furniture care products or aggressive cleaners. · When necessary, clean the dishwasher's controls with a soft cloth. · Occasionally check the internal dispensers, door seal and water inlet filter (if fitted) for dirt and clean them, if necessary. Cleaning the filters 3 The filtersDirty filters regularly checkedwash must be and cleaned. Turn the handle about ¼ of a turn anticlockwise (A) and remove the filter system (B). 3. Grasp the grip hole on the fine filter (1) and remove it from the micro-filter (2). Remove the flat filter (3) from the base of the washing compartment and clean both surfaces thoroughly. Insert the filter system in place and lock it by turning the handle clockwise as far as it will go. Ensure that the flat filter does not protrude above the base of the washing compartment. 1 Under no circumstances may the dishwasher be used without its filters. 23 Cleaning the spray arm jets Regularly check the jets in the spray arms for blockages. When cleaning is necessary, remove spray arm from the fixture and clean jets with a pointed object (wire or needle). Then rinse out the spray arm using a strong jet of water. 3 Do not damage the jet opening. Upper basket spray arm 1. Place cleaned upper basket spray arm back in position against the connecting piece: press the two together firmly, until you feel them snap into place. 24 Bottom spray arm 1. Place bottom spray arm back in position against connecting piece and press down firmly, until you feel it snap into place. 25 What to do if. . . Remedying small malfunctions If the acoustic signal is activated, warning tones sound if there are faults. If one of the following fault codes is displayed in the multi-display during operation: ­ Fault codeÅ 10 (Problems with water inlet), ­ Fault codeÅ 20 (Problems with water drainage), please have a look at the following table. When the fault is remedied, press the button for the cycle that has started. With other fault codes ("Å " followed by a number): ­ Abort the dishwashing cycle. If the fault is displayed again, please contact your local Service Force Centre and inform them of the fault code. Malfunction Possible cause Remedy Water tap is blocked with limescale Check the tap and have it repaired, if or is faulty. 1 short warning tone, continuously repeated, can be heard, the cycle indicator for the selected wash program is flashing: the control indicator lights up: fault code Å 10 is displayed in the multi-display: (Problems with water inlet) The filter (where present) in the threaded hose fitting on the tap is blocked. Cancel the dishwashing cycle (see chapter: Starting a dishwashing cycle), clean filters (see chapter: Cleaning the filters), then start the dishwashing cycle again. Check the position of the hose. Filters in the base of the washing compartment are blocked. Water supply hose has not been correctly positioned. Clean the siphon. [. . . ] · The appliance has been used for normal domestic purposes only, and in accordance with the manufacturer's instructions. · The appliance has not been serviced, maintained, repaired, taken apart or tampered with by any person not authorised by us. · All service work under this guarantee must be undertaken by a Service Force Centre. · Any appliance or defective part replaced shall become the Company's property. [. . . ]