User manual AEG-ELECTROLUX ESL6231

[. . . ] Any electrical and plumbing work required to install this appliance should be carried out by a qualified and competent person. Care must be taken to ensure that the appliance does not stand on the electrical supply cable. The sides of the dishwasher must never be drilled to prevent damage to hydraulic components. q q Isolate the appliance from the power supply and turn off the water supply after use. This product should be serviced by an authorised service technician, and only genuine spare parts should be used. [. . . ] In this case the rinse aid indicator light will always remain illuminated when the machine is switched on. Before the start of the washing programme put the "3 in 1" detergent in the detergent dispenser. NOTE: If the drying results are not satisfactory we recommend that you: 1. Set the rinse aid dosage to position 2. If you decide to turn back to the use of the standard detergent system we advise that you: q q Fill up the dispensers for salt and rinse aid again. Adjust the water hardness setting to the highest setting perform up to 3 normal washing programmes without loading any dishes. Adjust the water hardness setting according to the hardness of the water in your area. Adjust the rinse aid dosage. q q NOTE: When using 4 in 1 detergent tablets that integrate also anti-glass corrosion agent into "3 in 1" formula, please follow the same instruction as given for "3 in 1" detergents above. 10 Washing Programmes Programme Degree of soil and type of load Press the programme button Cycle description (2) Consumption values Programme duration (in minutes) Energy consumption (in kWh) Water consumption (in litres) Anti+Bac 70° Heavy soil. Crockery, cutlery, pots and pans 70° Hot prewash Main wash up to 70°C 2 warm rinses 1 hot rinse Drying Cold prewash Main wash up to 65°C 1 cold rinse 1 hot rinse Drying Cold prewash Main wash up to 50°C 1 cold rinse 1 hot rinse Drying Main wash up to 60°C 1 hot rinse 1 cold rinse (to avoid food scraps from sticking together). This programme does not require the use of detergent. 120 - 130 1. 7 - 1. 9 23 - 25 Normal 65° Normal soil. Crockery and cutlery 65° 95 - 105 1. 3 - 1. 5 19 - 21 (1) Normal-Eco 50° Normal soil. Crockery and cutlery 50° 90 0, 6 16 - 17 Quick 30I 60° Light soil. Once the delay start has elapsed the programme will start automatically. NOTE: the start of the programme or the countdown of the delay start will occur only after the closure of the dishwasher door, until this moment it is possible modify the set made. 5. To interrupt or cancel a washing programme in progress Interrupt or cancel a washing programme in progress ONLY if it's absolutely necessary Attention!Open the door carefully. Interrupt a washing programme in progress Open the dishwasher door; the programme will stop. Close the door; the programme will start from the point at which it was interrupted. Cancel a washing programme in progress Open the dishwasher door. Press simultaneously function buttons 2 and 3 for about 2 seconds, the indicator light of the button corresponding to the running programme starts flashing. 12 Maintenance and Cleaning Clean the external surfaces of the machine and control panel with a damp soft cloth. Never use abrasive products, scouring pads or solvent (acetone, trichloroethylene etc. . . . ). Ensure that the seals around the door, the detergent and rinse aid dispensers are cleaned regularly with a damp cloth. We recommend every 3 months to run a 65°C wash programme without dishes using detergent. Attention! Under no circumstances may the dishwasher be used without filters. Incorrect repositioning and fitting of the filters will produce poor washing results. NEVER try to remove the upper spray arm. If soil residue has clogged the holes in the upper spray arm, remove them with a cocktail stick / toothpick. Cleaning the filters The filters must be checked and cleaned from time to time. [. . . ] Please keep it with your proof of purchase documents in a safe place for future reference should you require service for your Electrolux appliance. 8. You may not make a claim under this warranty unless the defect claimed is due to faulty or defective parts or workmanship. Electrolux is not liable in the following situations (which are not exhaustive): (a) The Appliance is damaged by: (i) accident (ii) misuse or abuse, including failure to properly maintain or service (iii) normal wear and tear (iv) power surges, electrical storm damage or incorrect power supply (v) incomplete or improper installation (vi) incorrect, improper or inappropriate operation (vii) insect or vermin infestation. (b) The Appliance is modified without authority from Electrolux in writing. [. . . ]