User manual AEG-ELECTROLUX ESI6601ROX

[. . . ] If not, put in a horizontal position in the upper basket or in the knife basket. Types of salt that are not specified for dishwashers can cause damage to the water softener. ⷠFill the appliance with salt before you start a washing programme. Remaining salt in the appliance can cause corrosion or make a hole in the bottom of the appliance. [. . . ] ­ If the water inlet hose or the safety valve are damaged, immediately disconnect the mains plug from the mains socket. Make sure that the electrical information on the rating plate agrees with the power supply. Make sure not to squash or cause damage to the mains plug and cable behind the appliance. ⷠMake sure that there is access to the mains plug after the installation. to discard the appliance · To prevent the risk of injury or damage: ­ Disconnect the mains plug from the mains socket. ⷠIf an accident occurs with these detergents, contact immediately a physician. ⷠIf the detergent gets into the mouth, contact immediately a physician. ⷠIf the detergent gets into the eyes, contact immediately a physician and clean the eyes with water. ⷠKeep dishwasher detergents in a safe area and out of children touch. ⷠDo not keep the appliance door open when there is detergent in the detergent dispenser. ⷠFill the detergent dispenser only before you start a washing programme. the rinse aid dispenser automatically adds rinse aid during the last rinsing phase. Use of detergent To help the environment, do not use more than the correct quantity of detergent. If the washing programme has a prewash phase, put a small quantity of detergent on the inner part of the appliance door. Remove the spilled rinse aid with an absorbent cloth to prevent too much foam during the washing programme. You can set the rinse aid dosage between position 1 (lowest dosage) and position 4 (highest dosage). Do a check if these tablets are applicable for the local water hardness. When you set the multitab function, it stays on until you deactivate it. activate the multitab function before the start of a washing programme. You cannot activate the multitab function when the programme operates. Press and hold function buttons D and E until the multitab indicator light comes on. Press and hold function buttons D and E until the multitab indicator light goes off. [. . . ] ⷠIf you do not switch off the appliance, after three minutes from the end of the washing programme: ­ all indicator lights go off, ­ the display shows one horizontal bar, This helps to decrease energy consumption. press one of the buttons (not the on/off button) , the display and the indicator lights come on again. Auto Off The Auto Off function automatically switches off the appliance 10 minutes after the end of the washing programme. ⷠFirst remove the items from the lower basket, then from the upper basket. [. . . ]