User manual AEG-ELECTROLUX EK6163

[. . . ] S When operating the unit, care must be Taken that the cooling circuit does not get damaged. Should the cooling circuit get damaged then keep it clear of open fires and any type of ignition source. The room in which the unit is located should be ventilated for a few minutes. S This unit is only for household use as described in the operating instructions. [. . . ] Important The appliance is designed to operate at room temperatures between +10° and +32°C. The maintaining of the internal temperatures of the cooling and freezing compartments can no longer be guaranteed at room temperatures outside this range. Normal operation Set the temperature to a position between the two temperature symbols (warmer top, colder bottom) according to the desired cooling compartment temperature. A temperature of -18°C is reached in the freezing compartment from a temperature of 5°C or lower in the cooling compartment (see also Tips). This conditions are satisfied from an approximately central position of the controller. S Only small quantities should be frozen at One time so that the temperature in the freezer does not increase too much (max. The electronics sense that products need to be fro34 Ught into contact with products which are already frozen. Products which have been thawed out must not be re-frozen because foodstuffs can spoil. Variable inner doors The cover inserts in the inner doors can be adjusted somewhat and offer the option of a customized setting. To change the location of the inserts and bottle holder: first lift upwards and lift out, then set the required height and replace in the reverse sequence. Ice which has formed on the back wall is melted (about once per day, see also the tips). Other products can take up to 6 hours from room temperature down to the refrigerator temperature. Tor only defrosts about once per day, the ice formation on the rear wall in the refrigerator itself can be more marked than is usual in previous refrigerators. S Be careful that products do not come Into contact with the rear wall of the refrigerator so that they do not freeze to it and that, during defrosting, water does not get diverted into the refrigerator. ­ Oil and fats do not come into contact with the polymer parts and the door seals. ­ The coldest locations in the refrigerator for any setting of the temperature controller are at the back wall and above the lowest shelf. & Changing the light bulb A defective bulb must be replaced at once. ­ On the shelves from top to bottom: baked products, ready-made meals, dairy products, meat and sausages. ­ In the suspended trays from top to bottom: butter and cheese, tubes, small cans and eggs, large bottles. S Pull off the lamp protection cover from %), When fitting the new light bulb, you will need to reassemble the existing o-ring (fig. S Bulbs can be obtained from your local Faults The refrigerator was checked for correct function before delivery. The fault is easy to rectify by resetting the circuit breaker in question. [. . . ] Operating noise will be most audible immediately after the compressor cuts in. Noises which are not normal Unusual noise is normally the result of improper installation. The cooler must be installed or built-in so that it is level and stable. Under no circumstances must tubing come into contact with a wall, other furniture or with another tubing. [. . . ]