User manual AEG-ELECTROLUX EFA12545X

[. . . ] Adjust the flame intensity to direct it onto the bottom of the pan only, making sure that it does not engulf the sides. Deep fat fryers must be continuously monitored during use: overheated oil can burst into flames. Do not flambè under the range hood; risk of fire · This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. [. . . ] Connect the hood air outlet to the flange in the lower part of the junction using a rigid or flexible ø 150 tube (by installer's 10 choice). Position the upper chimney section and fix the upper part to the frame using the 2 screws 12c (2, 9 x 6, 5) provided. Similarly, position the lower chimney section and fix the lower part to the frame using the 2 screws 12c (2, 9 x 6, 5) provided. Before fixing the hood body to the frame: · From below, use the 4 screws 12f (M6 x 10)provided to fix the hood body to the frame. Connect the hood to the mains through a two-pole switch having a contact gap of at least 3 mm. Place the connectors in the junction box 24 and close it using the 2 screws 12e (2, 9 x 9, 5) provided. Fix the junction box to the hood body using the 2 screws 12c (2, 9 x 6, 5) provided. The hood can be switched on pushing directly onto the requested speed without firstly having to select 0/1 button . When pressed for 2 seconds it starts the lighting system in "courtesy light" mode. Such function can be stopped by pressing the touch control for 2 seconds or just by pressing it shortly in order to return to the normal lighting mode. When pressed the motor is stopped, regardless of the speed it is set to. When pressed the motor is set to the first speed By a brief pressing the motor is set to the second speed. By pressing the touch control for approximately 2 seconds the Delay function is enabled, i. e delayed shutdown of the appliance ensuring a complete elimination of the residual odours. [. . . ] Within 3 seconds press the touch control F until the key itself flashes to confirm as follows: · Press the touch control F for at least 4 seconds, until the touch control T1 flashes. Remove the 2 screws fixing the Lighting support, and pull it out of from the Hood. Replace with another of the same type, making sure that the two pins are properly inserted in the lamp holder socket holes. [. . . ]