User manual AEG-ELECTROLUX EDH97961W

[. . . ] under no circumstances should you attempt to repair the machine yourself. Repairs carried out by inexperienced persons may cause injury or serious malfunctioning. Items that have been soiled with substances such as cooking oil acetone, petrol, kerosene, spot removers, turpentine, waxes and wax removers should be washed in hot water with an extra amount of detergent before being dried in the tumble dryer. Danger of explosion: Never tumble dry items that have been in contact with inflammable solvents (petrol, methylated spirits, dry cleaning fluid and the like). [. . . ] appliance positioning · It is recommended that, for your convenience, the machine is positioned close to your washing machine. ⷠThe tumble dryer must be installed in a clean place, where dirt does not build up. ⷠAir must be able to circulate freely all round the appliance. Do not obstruct the front ventilation grille or the air intake grilles at the back of the machine. ⷠTo keep vibration and noise to a minimum when the dryer is in use, it should be placed on a firm, level surface. ⷠOnce in its permanent operating position, check that the dryer is absolutely level with the aid of a spirit level. Do not restrict the floor clearance through deeppile carpets, strips of wood or similar. This might cause heat built-up which If the appliance was not transported in an upright position, leave it to stand for 12 hours before connecting it to the electricity supply and using it for the first time, so that the oil can flow back to the compressor. The appliance must therefore not be installed on floors which are not resistant to high temperatures. ⷠWhen operating the tumble dryer, the room temperature must not be lower than +5°C and higher than +35°C, as it may affect the performance of the appliance. ⷠShould the appliance be moved, it must be transported vertically. ⷠThe appliance must not be installed behind the lockable door, a sliding door a door with a hinge on the opposite side to that of the appliance in such a way that a full opening of the dryer is restricted. Before appliance use all packaging parts and drying rack must be removed from the drum. Should the appliance power supply cable need to be replaced, this must be carried out by our Service Center. Door reversal To make it easier to load or unload the laundry, the door can be reversed. special accessories · Stacking kit These intermediate installation kits can be used to arrange the dryer and a washing machine (60 cm wide, front loaded) as a space-saving washer/dryer stack. Available from your Service Force Centre or your specialist dealer · draining kit Installation kit for direct draining of the condensed water into a basin , siphon , gully , etc. The water reservoir then no longer has to be drained, it must however remain in its intended position in the machine. Fixed hose has to be on the suitable height from minimum of 50 cm to maximum of 1 m from floor level and cannot be looped. Available from your Service Force Centre or your specialist dealer · Pedestal with the drawer To situate the dryer at the optimal height and have some additional space to store (e. Electrical connection Details on mains voltage, type of current and the fuses required should be taken from the type plate. The manufacturer declines any responsibility for damage or injury through failure to Read carefully the instructions supplied with the kit. [. . . ] Check the correct positioning of o-ring gasket before screwing back the door light cover. Do not operate the dryer when missing oring gasket on door light cover. Height x width x depth Drum volume Depth with loading door open Height can be adjusted by Weight when empty Loading volume (depends on Voltage Necessary fuse Total power Energy efficiency class Energy consumption (7 kg of cotton, pre-drained at 1000 rpm) 2) Average annual energy consumption Use Permitted ambient temperature programme)1) 85 x 60 x 58 cm 108 l 109 cm 1. They can deviate when the appliance is operated in domestic circumstances. [. . . ]