User manual AEG-ELECTROLUX EDH97950W

[. . . ] user manual Energy Star Low Energy Drying System EDH97950W EMAN_Energy Star_0409. indd 1 12/5/09 11:46:24 AM 2 contents electrolux Congratulations Congratulations and thank you for choosing our EDH97950W condenser dryer. Before you use your condenser dryer, we recommend that you read through the whole user manual, which provides information about the condenser dryer and its functions. To avoid the risks that are always present when you use an electrical appliance it is important that the condenser dryer is installed correctly and that you read the safety instructions carefully to avoid misuse and hazards. We recommend that you keep this instruction booklet for future reference and pass it on to any new owners. [. . . ] Buzzer The appliance is supplied with the Buzzer function deactivated. When activated, the buzzer sounds: ­ At the end of the cycle ­ When the anticrease phase starts or ends ­ When the cycle is interrupted To activate it: 1. Press the Buzzer button ­ the display shows the icon: Time Use the Time button to select the program duration after setting the Time program. Press the Time button repeatedly until the desired program duration is shown in the display, e. g. If the program duration is not selected, the duration is automatically set to 10 mins. Delay With the Delay button, you can delay the start of a program by between 30 minutes and a maximum of 20 hours. Press the Delay button as many times as necessary until the required time of the delay appears on the display, e. g. if the program is to be started in 12 hours. If the display is showing and you press the button again, the time delay will be cancelled. The amount of time remaining until the program is set to start is continuously displayed (e. g. 30' etc). To permanently activate or deactivate buzzer see the chapter Machine settings. EMAN_Energy Star_0409. indd 13 12/5/09 11:46:29 AM 14 daily use electrolux Child lock The child lock can be set to prevent a program being accidentally started or a program in operation being accidentally changed. The child lock can be activated or deactivated by holding down the Buzzer and Time buttons simultaneously for 5 seconds. Changing program To change a program which has been selected by mistake once the program has started, first turn the program selector to off and then reset the program. If the child lock is set: ­ before program is started, the appliance cannot be used ­ after program is started, program in operation cannot be changed The icon appears in the display to indicate that the child safety device is activated. The child safety device is not deactivated once the program comes to an end. If you want to set a new program, you must first deactivate the child lock. Starting the program The program can no longer be changed directly once the program has started. If nevertheless there is an attempt to change the program on the program knob, the program progress display and the maintenance indicators flash. If an option button (excluding the Buzzer button) is pressed, appears on the display. The drying program is not however affected by this (laundry protection). Drying cycle complete / removing laundry Once the drying cycle is complete, the display shows the anticrease icon and flashing as well as warning lamps: filter and full tank. If the Buzzer button has been pressed, an acoustic signal sounds intermittently for about one minute. Press the Start/Pause button. The program progress is shown by elapsing dry time and animated icon on LCD. The drying cycles (except from the Wool program) are automatically followed by an anticrease phase which lasts around 30 minutes. This keeps the laundry loose and EMAN_Energy Star_0409. indd 14 12/5/09 11:46:30 AM electrolux care and cleaning 15 Care and cleaning free of creases. (The laundry should be taken out towards the end of the anticrease phase at the latest to prevent creases from forming. ) If Long anticrease function has been selected, the anticrease phase is lengthened by 60 minutes. [. . . ] Proof of purchase is required before you can make a claim under this warranty. You may not make a claim under this warranty unless the defect claimed is due to faulty or defective parts or workmanship. Electrolux is not liable in the following situations (which are not exhaustive): (a) The Appliance is damaged by: (i) accident (ii) misuse or abuse, including failure to properly maintain or service (iii) normal wear and tear (iv) power surges, electrical storm damage or incorrect power supply (v) incomplete or improper installation (vi) incorrect, improper or inappropriate operation (vii) insect or vermin infestation. (b) The Appliance is modified without authority from Electrolux in writing. [. . . ]