User manual AEG-ELECTROLUX EDH3386GDW

[. . . ] If you have washed your laundry with stain remover you must execute an extra rinse cycle before loading your tumble dryer. Please make sure that no gas lighters or matches have accidentally been left in pockets of garments incase they are loaded into appliance Never stop a tumble dry before the end of the drying cycle unless all items are quickly removed and spread out so that the heat is dissipated. The final part of a tumble dryer cycle occurs without heat ( cool down cycle ) to ensure that the items are left at a temperature that ensures that items will not be damaged. The tumble dryer is not to be used if industrial chemicals have been used for cleaning. [. . . ] Instead it should be taken to the appropriate collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local council, your household waste disposal service or the shop where you purchased the product. Your dryer will function most economically if you: ­ Always keep the ventilation slots on the base of the dryer unobstructed; ­ Use the loading volumes specified in the programme overview; ­ Ensure you have good ventilation in the installation room; ­ Clean the micro-fine filter and fine strainer after each drying cycle; ­ Spin the laundry well before drying. Environmental information The packaging materials are environmentally friendly and can be recycled. The heat pump of your dryer contains a closed refrigerant circuit filled with a refrigerant which is free from fluoro-chloro-hydrocarbons. When a unit is no longer being used: · Pull the plug out of the socket. This prevents children from trapping themselves inside and endangering their lives. Only tip the appliance on its left side to transport (see illustration), if it cannot be transported in an upright position. The appliance must not be installed behind the lockable door, a sliding door a door with a hinge on the opposite side to that of the appliance in such a way that a full opening of the dryer is restricted. If the appliance was not transported in an upright position, leave it to stand for 12 hours before connecting it to the electricity supply and using it for the first time, so that the oil can flow back to the compressor. Special program with anti-crease mechanism for easy care fabrics such shirts and blouses; for minimum ironing effort. Place fabrics in the dryer straight after spinning; once dried, immediately remove fabrics and place on a clothes hanger. For drying woollen fabrics after they have been washed, using warm air at minimum mechanical load (Follow section "Sorting and preparing washing"). Special programme, lasting around 10 minutes, for refreshing or gently cleaning textiles with commercially available dry cleaning sets. (Only use those products which are declared as suitable for the drier by the manufacturer; please observe the manufacturer's instructions for use. Sort by care label: The care labels mean: Drying in the tumble dryer possible in principle Drying at normal temperature Drying at reduced temperature Drying in the tumble dryer not possible Important!Do not place in the appliance any wet laundry which is not specified on the care label as being suitable for tumble-drying. This appliance can be used for all wet laundry items which are labelled as suitable for tumbledrying. Do not dry new, coloured textiles together with light-coloured laundry items. Before the drying the cycle spin the woollen textiles as well as possible (max. Only dry woollen textiles together of similar or the same material, colour and Please dry heavy laundry items made of wool separately. [. . . ] 58 electrolux Changing the bulb for interior lighting Only use a special bulb which is designed specially for dryers. When the appliance is switched on, the interior lighting switches itself off after 4 minutes when the door is open. Before replacing the bulb, disconnect the mains plug; with a permanent connection: fully unscrew or deactivate the fuse. Unscrew cover above the bulb (this can be found directly behind the loading aperture, at the top; refer to "Description of machine" section. [. . . ]