User manual AEG-ELECTROLUX DD9996-B

[. . . ] Adjust the flame intensity to direct it onto the bottom of the pan only, making sure that it does not engulf the sides. Deep fat fryers must be continuously monitored during use: overheated oil can burst into flames. Do not flambè under the range hood; risk of fire · This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. [. . . ] Connect the hood to the mains supply by means of a bipolar switch with at least 3 mm contact gap. In order to align the hood it is necessary to adjust the Vr-screws from inside the hood. Fit again the metal filters into their seats and see Part USE to close the upper panel. Attention: If any barrier occurs in its way during the panel opening or closing, the upper panel stops for 1 sec and starts again the other way round. When installing the ducted version, connect the hood to the chimney using either a flexible or rigid pipe ø 150 or 120mm, the choice of which is left to the installer. Fix the pipe in position using sufficient pipe clamps (not supplied) . Fix the air outlet grid 8 on the recirculation air outlet using the 2 screws 12d (2, 9 x 9, 5) provided. Remove the metal filters (See Part "MAINTENANCE") and make sure that the connector piece of the supply cable is correctly inside the hood socket. Slightly widen the two sides of the upper chimney and hook them behind the brackets 7. Slightly widen the two sides of the chimney and hook them between the upper chimney and the wall, making sure that they are well seated. Fix the lower part laterally to the hood body using the 2 screws 12c (2, 9 x 9, 5) supplied. Upper panel closed: when pressed for about two sec-ond it opens the upper panel. Upper panel open: when shortly pressed it switches the motor and the lights on/off. The function is suitable for cooking conditions when vapours and smells are of the at most emission. By pressing this key it is possible to set up the motor to a suction speed at 100 m3/h . By pressing this key for about 2 seconds it is possible to reset the filter saturation alarm. c indicates that the charcoal filter satura-tion alarm has been activated , and the filter has to be replaced. By pressing this key the intensity of the lighting sys-tem can be modified up to five levels. It switches the lights on and off (at maximum speed) inspite of the panel's position. Upper panel closed: when pressed for about two sec-ond it opens the upper panel . [. . . ] Press the E-key for about 5 seconds until an animation appears on the display · Within 5 seconds press the D-key to activate/deactivate charcoal filter saturation alarm. Replace with another of the same type, making sure that the two pins are properly inserted in the lamp holder socket holes. The hood panel opening and closing mechanism is controlled by a starter motor which is activated by a fuser. In case the fuser gets damaged when the panel is closed it is be necessary to manually unblock the panel. [. . . ]