User manual AEG-ELECTROLUX 7509D-M-A

[. . . ] If the cooker hood is connected to chimneys no longer in use, it is advisable to seek the consent to the competent chimney-sweeper. if the cooker hood is installed in the evacuation mode , the requirements of the concerned authorities have to be observed. An adequate air inlet having the same size as the air outlet is to be ensured. [. . . ] Partially loosen the four screws fixing the lower part of the cooker hood to the upper part 1), adjust the lower part of the cooker hood 2) in the desired position and tighten the screws definitively. Connection to the evacuation duct may be realised through a round or flat duct. If you wish to replace the factory fitted front strip with a wooden one or with a front strip made with the same material as the kitchen, remove the five screws. If the cooker hood is to be installed in recirculation mode then charcoal filters (on request) must be provided. Fix the new front strip with the central screw before and, later, fasten the other four screws definitely. Fit the charcoal filters ensuring that they click into position correctly. The cooker hood can be installed in two different ways: RECIRCULATION FITTING: using two charcoal filters to catch the odours and to recirculate the air back into the kitchen. The ducting should be long enough to project through the hole in the top of the cabinet. If you wish to install the appliance in evacuation mode, the charcoal filters are not required. Fit the venting grille over the ducting and screw the grille to the top using the screws provided. Your appliance must be connected to fixed wiring via the use of a double pole switched fused spur outlet with or without pilot lamp. We strongly recommend the appliance is connected by a qualified electrician who is a member of the NICEIC who will comply with the IEE and any local regulations. Attention should be taken when installing the ducting to choose the shortest possible run with the minimum number of bends. The use of bends may cause a loss of air capacity and should be avoided where possible. NOTE: The terminology "DOUBLE POLE" means that both the live and neutral supplies are switched and disconnected at the same time. The terminations laballed SUPPLY are for connection for the internal house wiring and the terminations labelled LOAD are for the appliance. [. . . ] Charcoal filter KF 7509 Wall box MKZ Outside dimensions for the hole on the wall Evacuation duct 120 mm Ø Aluminium Evacuation duct 125 mm Ø Aluminium E. Attention: To clean the cooker hood disconnect the appliance from the mains supply. Control panel should be cleaned only with a damp cloth and mild detergent. [. . . ]