User manual ADVENT ADVW801

[. . . ] It is only designed to work with RCA-type line/variable outputs or headphone outputs. NOTE For more information on hooking up and using the transmitter with various outputs, please see More Helpful Information beginning on page 12. Select from the following options to power the ADVW801 speaker: Make certain the batteries in the pack (I) are rechargeable. B Insert the power cord from the 15 V AC adapter (Q) into the battery pack input jack. [. . . ] Source is clearly heard through the speaker, indicating the speaker is tuned to the signal from the transmitter. ' Jacks designated for phono, CD, LD, DVD or tape playback (PB) are inputs and will not work for purposes of installing the transmitter. Fixed-level outputs from TVs are usually marked as `Constant, ' `Fixed, ' or `Select. ' If they are not marked as such, they are probably variable outputs (see About Variable-Level Outputs, page 13). HINT When connecting to the fixed audio outputs of a VCR, remember that for the wireless system to work, the VCR must be active. In other words, turn the TV on to the channel you would normally use to watch a videotape (channel 3 or 4), turn the VCR on, then press the TV/VCR button on your VCR remote control one time to make the VCR the controlling piece of equipment. At this point, whatever channel is showing on the tuner for the VCR should be the channel playing on the TV. This configuration gives independent volume control through the TV (using the TV remote control) and at the speaker. HINT If your VCR (or other RCA-type audio source you are connecting to) is mono (a single audio output), you need to acquire another RCA "Y" Cable. Connect the dual RCA plugs from the "Y" Cable Adapter (S) to the 2 female RCA jacks on the second "Y" cable, then connect the single male RCA plug of the second "Y" cable to the single audio output of the VCR. Is recommended when using a single speaker or if using more than one speaker in different locations. for monaural operation , set the Mono/Stereo Switch (D) to "MONO" on each speaker. B Stereo operation: You will need an additional ADVW801 speaker in order to utilize the stereo option. For stereo operation, set the Mono/Stereo Switch (D) to "L" on the speaker located to the left of the listener, and set the other speaker to the "R" position. A variable-level output, such as a headphone jack or certain RCA-type outputs, provides an audio signal to the transmitter that changes in relation to volume level on the audio source. As the volume of the audio source goes up and down, so too does the audio signal strength sent to the transmitter. This can affect the quality of sound you hear at the speaker, and may require increasing or decreasing the volume level of the audio source to achieve a suitably strong audio signal for use with the ADVW801 system. If you are unsure which, if any, of your outputs are fixed, refer to the TV instruction manual. [. . . ] We warrant that for one year from the date of purchase this product will be free from defects in materials or workmanship. This device complies with part 15 of the Federal Communications Commission (FCC) rules. Operation is subject to the following two conditions: 1) This device may not cause harmful interference and 2) This device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. [. . . ]