User manual ADVENT ADR460

[. . . ] The ADR460 is easy to use, easy to program, and it gives you total control--at the touch of your fingertips!Your universal remote requires 2 new AAA alkaline batteries (sold separately). Make sure your component(s) are turned on and your TV is tuned to the appropriate video source. Press the component button whose menu you wish to access (TV, VCR· NOTE: Some functions of some brands may not be fully supported. [. . . ] ⷠYou must put the remote in the correct mode by pressing the corresponding component key (TV, VCR· dVD , AUX or SAT· CBL) so the remote knows which component you want to operate. ⷠTo program the 4 component universal remote to operate a combination unit (TV/VCR or TV/DVD), first try the VCR or DVD codes for your brand. Some units, however, require that you program both the TV key (using the TV codes) and the VCR· To program the 4 component universal remote to operate a combination unit (VCR/DVD), program the VCR key using the VCR codes and then program the AUX key using the DVD codes. You must put the remote in the correct mode by pressing the corresponding component key (TV, VCR· dVD , AUX or SAT· CBL) so the remote knows which component you want to operate. ⷠYou may have pressed an invalid key for the mode the remote is in (for example, REC only works in VCR Mode). You must put the remote in the correct mode by pressing the corresponding component key (TV, VCR· dVD , AUX or SAT· CBL) so the remote knows which component you want to operate. ⷠRemove any obstacles between the remote and the component. Make sure the batteries are properly installed (See Battery Installation). Remove the batteries, then press and hold the number 1 key on the remote for several seconds to reset the microprocessor inside the remote. Release the number 1 key, reinstall the batteries, and try the remote again. You must put the remote in the correct mode by pressing the corresponding component key so the remote knows which component you want to operate. ⷠIf you're trying to change channels, try pressing the OK key after entering the channel number as this is a requirement of certain models and brands. ⷠThere is a possibility that a programmed code may only be able to control some of your component features (e. If the component can be turned on and off, make sure you press the CHAN UP/DOWN key to see if the component responds. As a safety feature, you must press the REC key twice to begin recording. If the safety tab is removed the tape is write-protected and you cannot record onto that tape. You must put the remote in the correct mode by pressing the corresponding component key (TV, VCR· dVD , AUX or SAT· CBL) so the remote knows which component you want to operate. Make sure your component(s) are turned on and your TV is tuned to the appropriate video source and use the input key to toggle through video sources connected to your TV. If that's the case, you'll need to use your original remote control to access menu functions for these components. If your TV, VCR, DVD, DVR, satellite receiver or cable box does not respond after you have tried all the codes for your brands, or if your brand is not listed, try searching for your code via the Code Search Entry Method. [. . . ] The number that causes the indicator light to blink is the first digit of your code. The Menu function on your remote is used to make changes on selected settings. The TV Menu is used to make changes in the TV settings, such as changing color, channels and timers. The SAT Menu navigates through your satellite receiver's Guide screens, to make changes in the satellite settings, such as channel lists and passwords. [. . . ]