User manual ADVANCE X-PREAMP

[. . . ] Before any transportation, your product must be packed correctly in order to avoid any damage. SAFETY INSTRUCTIONS READ INSTRUCTIONS All the safety and operating instructions should be read before the appliance is operated. RETAIN INSTRUCTIONS The safety anil operating instructions should be retained for future use. HEED WARNINGS All warnings on the appliance and in the operating instructions should be adhered to. [. . . ] Exposed to rain: or • The appliance does not appear to operate normally or exhibits a marked change in performance; or • The appliance has been dropped, or the enclosure damaged. SERVICING The user should not attempt to service the appliance beyond that described in the operating instructions. All other servicing should be referred to qualified service personnel. STANDBY/ON POWER BUTTON Press this button to turn ON your appliance, power is supplied to your unit and it becomes operational, the STANDBY indicator white lights after few seconds. (The main power switch is located on the back panel and must be ON in order to use STANDBY function). When set to STANDBY the main power is cut-off and the unit is no longer fully operational except for the micro controller. IMPORTANT: When the BYPASS mode is OFF, two additionnal menus appears to control treble and bass levels. If BYPASS ON is selected and if you push treble or bass buttons on the remote, the display will indicate “KEY ERR“ to advise you that in this mode you can’t control treble and bass levels. MULTIFUNCTIONS BUTTON This button has three functions: you can adjust the level of the sound, you can select the different menus and options of your preamplifier (Inputs, Balance, Bypass (On or Off), Treble (only if bypass is Off), Bass (only if bypass is Off), Dimmer and Info (software version). The voltage indicator will light on and the stand by button located on the front panel will light on in red. Push the standby button (front panel) and the light will become white, the left display indicate ADVANCE and the right display the level of the volume, then after a short time, the left display indicates the last selected source when the preamplifier was shut Off. At that time, you can select the different menus of your preamplifier. Push one time the center of the button and the left display indicates INPUT. Turn the button and you can choose a different source, push again the center of the button to confirm your choice. A > before the source indicate that your choice has been confirmed. WARNING You can eliminate this confirmation time by using the remote control Selections and confirmations of others menus and options work identically. These inputs are suitable for any line level source equipment such as tuners, CD players, DVD, MP3 players, etc. They should not be connected to the digital output of a CD player or any other digital device. PHONO INPUT AND GROUND TERMINAL You can connect your turntable on the RCA connectors left (L) and right (R). The output level of those pre-out can be adjusted by the volume button of your preamplifier. [. . . ] AES3 uses 110 ohm shielded twisted pair (STP) cable with XLR connectors up to a distance of 100 meters. REC OUTPUT This analog audio input and output are for connecting a recorder with an analog audio input and output, such as a cassette deck, MD recorder, etc. And use the high quality DAC converter of your preamplifier in order to obtain a better sound result. USB INPUT Note: Do not turn on the unit until all connections have been made. [. . . ]