User manual ADVANCE MPP-206

[. . . ] Before any transportation, your product must be packed correctly in order to avoid any damage. RETAIN INSTRUCTIONS The safety anil operating instructions should be retained for future use. HEED WARNINGS All warnings on the appliance and in the operating instructions should be adhered to. [. . . ] SERVICING The user should not attempt to service the appliance beyond that described in the operating instructions. All other servicing should be referred to qualified service personnel. POWER-CORD PROTECTION Power-supply cords should be routed so that they are not likely to be walked on or pinched by paying particular attention to cords at plugs, convenience receptacles, and the point where they exit from the appliance. CLEANING The appliance should be cleaned only as recommended by the manufacturer. POWER LINES An outdoor antenna should be located away from power lines. NON-USE PERIODS The power cord of the appliance should be unplugged from the outlet when left unused for a long period of time. OBJECT AND LIQUID ENTRY Care should be taken so that objects do not fall and liquids are not spilled into the enclosure through openings. STANDBY/ON POWER BUTTON Press this button to turn ON your appliance, power is supplied to your unit and it becomes operational, the STANDBY indicator blue lights after few seconds. (The main power switch is located on the back panel and must be ON in order to use STANDBY function). When set to STANDBY the main power is cut-off and the unit is no longer fully operational except for the micro controller. Also on this input, you have the possibility to use others sources with same audio signal output like tuner, tape, MD, etc. TUNER INPUT Press this button to select the tuner as your listen source. Also on this input, you have the possibility to use others sources with same audio signal output like tuner, tape, MD, etc. BOUTON DE VOLUME VYour amplifier used a rotary type knob to control the 2 channel output sound level (left and right). [. . . ] You also have the possibility to use on those connectors signal processors such as equalizers. SUBWOOFER OUT: Connect this outputs to the subwoofer power amplifier to drive your subwoofer speaker, or connect to the subwoofer speaker with built in amplifier. CROSSOVER FREQUENCY 150Hz/75Hz: Press this button to set the crossover frequency of the subwoofer at 150Hz or 75Hz. [. . . ]