User manual ADVANCE MAP-308

[. . . ] Before any transportation, your product must be packed correctly in order to avoid any damage. SAFETY INSTRUCTIONS READ INSTRUCTIONS All the safety and operating instructions should be read before the appliance is operated. RETAIN INSTRUCTIONS The safety anil operating instructions should be retained for future use. [. . . ] NON-USE PERIODS The power cord of the appliance should be unplugged from the outlet when left unused for a long period of time. OBJECT AND LIQUID ENTRY Care should be taken so that objects do not fall and liquids are not spilled into the enclosure through openings. DAMAGE REQUIRING SERVICE The appliance should be serviced by qualified service personnel when: • The power-supply cord or the plug has been damaged; or • Objects have fallen, or liquids have spilled into the appliance; or • The appliance has been. Exposed to rain: or • The appliance does not appear to operate normally or exhibits a marked change in performance; or • The appliance has been dropped, or the enclosure damaged. SERVICING The user should not attempt to service the appliance beyond that described in the operating instructions. All other servicing should be referred to qualified service personnel. wARNING ATTENTION No good Good Your product is designed to be placed on a firm and level surface. Don’t place the unit sideways, a big power exerts on the single side of the plate. STATIC ELECTRICITY ELECTRICITÉ STATIQUE The window of the meters is antistatic treated, also, it’s very important to clean it with an antistatic approved liquid. Inputs Sélecteur d’entrées numériques (MAP-308 seulement) Digital inputs selector (MAP-308 only) Diminution du volume Decrease volume Fonction Stand-by Standby function Entrées Tuner et PC Tuner and PC inputs Entrée Phono Phono input Fonction silence Mute function Augmentation du volume Increase volume IMPORTANT To switch on the Power amps direct function, please push “Normal/Amp” button of the remote control during 3 seconds. To cancel this mode, please push on the “Normal/Amp” button of the remote during 3 seconds. STANDBY/ON POWER BUTTON Press this button to turn ON your appliance, power is supplied to your unit and it becomes operational, the STANDBY indicator blue lights after few seconds. (The main power switch is located on the back panel and must be ON in order to use STANDBY function). When set to STANDBY the main power is cut-off and the unit is no longer fully operational except for the micro controller. L CD INPUT Press this button to select the CD as your listen source. Also on this input, you have the possibility to use others sources with same audio signal output like tuner, tape, MD, etc. TUNER INPUT Press this button to select the tuner as your listen source. Also on this input, you have the possibility to use others sources with same audio signal output like tuner, tape, MD, etc. [. . . ] To com back to the original normal mode, push again this button during about 3 seconds. OPTICAL (1), COAXIAL (3) AND AES/EBU (1) DIGITAL INPUTS Your amplifier integrate a DAC (Digital audio converter) with 5 inputs, 3 are coaxials, 1 is optical and 1 is AES/EBU. | GROUND SCREW TERMINAL FOR TURNTABLE Connect the ground wire from your turntable here. [. . . ]