User manual ADVANCE KUBIK K11S

[. . . ] Sofa, rug, or similar surface that may block the ventilation openings; or, placed in a built-in installation, such as a bookcase or cabinet that may impede the flow of air through the ventilation openings. HEAT The appliance should be situated away from heat sources such as radiators, heat registers, stoves, or other appliance (including amplifiers) that produce heat. POWER SOURCES The appliance should be connected to a power supply only of the type described in the operating instructions or as marked on the appliance. [. . . ] Under no circumstance should plants or fish bowls be placed on the products. Heat The loudspeakers should not be placed near any heat source such as radiators, open fires, stoves, direct sunlight and any other appliance that produces heat. The Elysée loudspeakers are designed for use within the home environment. Exposure to extreme temperatures and humidity when placed on patios or open conditions could adversely affect the wooden cabinets. Cleaning Great care and attention has gone into the materials chosen to produce the Elysée range of loudspeakers. It is our intention that they should provide a lifetime of musical pleasure. A gentle wipe with a dry, clean cloth is allthat is required to remove any dust. On high lacquer finishes, please ensure the duster is free of any foreign objects to avoid scratching the surface. Avoid touching the drive units whilst cleaning, as any damage will impair their performance. INTRODUCTION The Kubik range of loudspeaker perpetuates the long time commitment of AA to the faithful reproduction of sound. Loudspeakers Unpacking : if you think your loudspeakers have been damaged during transport, please contact immeditaly your Advance Acoustic authorised retailer. A good place allows to control the room defects, and avoids annoying acoustic reflections. We advise you not to place K11s speakers directly against the wall, either in one corner of the room, or directly on the ground ( please use the joined spikes). The reflective surfaces near to the loudspeakers can have some negative effects on the stereo image. If so, please try to move slightly the loudspeakers inside of the listenning zone till you obtain the better sound. It’s really important to notice that the K11s loudspeakers have the bass drivers inside so face to face. In some cases of reverberation room whose walls are far more than a metre of loudspeakers, it’s possible to reverse the loudspeakers position. K11s installation Wiring system : Please check if all the material is switched off before starting the connections. [. . . ] The liability of advance Acoustic is limited to the repair or replacement of the defective parts ( at the discretion of Advance Acoustic) and under no circumstances extends to consequential losses , dammage or accident. Advance Acoustoc can replace one model ( if this is no more manufactured) by another model at the same cost. 2) 3) 4) 5) Direct heritage of our famous laboratory speaker EL-1000, our Advance Acoustic concept is to integrate the woofer driver on the side of each speaker. [. . . ]