User manual ADDONICS ZESU2CS

[. . . ] Enclosure Overview Fan Switch USB Port Screw 1 Screw 2 Addonics TECHNOLOGIES Power Connector eSATA Port Zebra eSATA/USB Combo Drive Enclosure Model: ZESU2CS Removing the front panel You can remove the front panel of the enclosure to access the drive drawer of the optical drive. User's Guide Step 1 Loosen the two screws from the rear panel. [. . . ] If not installed and used in accordance with the instructions, it may cause harmful interfer ence to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If the equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment on and off, the user is encouraged to try and correct the interference by one or more of the following suggestions. Reorient or relocate the receiving antenna Increase the distance between the equipment and the receiver Connect the equipment to a different power outlet other than the one where receiver is connected Consult a certified television or radio technician SATA Cable 15-Pin SATA Power Connector Optional Configuration: For Connecting IDE hard drive Technical Support If you need assistance to get your unit functioning properly, please call Addonics Technical Support. Our technical staff will be happy to assist you, but they will need your help to do so. Calling the technical support staff without all the proper information can be both time consuming and frustrating. [. . . ] FREE Software Drivers for all Addonics Technologies Products are available 24 hours per day at the World Wide Web Site: www. addonics. com Contact Information Phone: 408-573-8580 Fax: 408-573-8588 Email: http://www. addonics. com/sales/query/ Internet: http://www. addonics. com TECHNICAL SUPPORT Phone: 408-453-6212 Hours: 8:30 am - 6:00 pm PST Email: http://www. addonics. com/support/query/ Y-Cable Using the SATA to IDE converter, you can use IDE hard drives on the Zebra enclosure ADSAIDE converter Screw holes Step 3 Use the enclosed screws to secure the hard drive to the tray. Step 4 After the hard drive is installed, slide the tray back into the enclosure and then fasten the two screws properly. [. . . ]