User manual ADDONICS ZESSIU3CS

[. . . ] Enclosure Overview Screw 1 Switch Screw 2 Addonics TECHNOLOGIES Fan eSATA Port Power Connector Removing the front panel Z USB3. 0 / eSATA Combo Drive Enclosure for SATA or IDE Hard drive or Optical drive Model: ZESSIU3CS You can remove the front panel of the enclosure to access the drive drawer of the optical drive. User's Guide Step 1 Loosen the two screws from the rear panel. [. . . ] However, there is no guarantee that interference will not occur in a particular installation. If the equipment does cause harmful interf erence to radio or television reception, which can be determined by turning the equipment on and off, the user is encouraged to try and correct the interference by one or more of the following suggestions. Reorient or relocate the receiving antenna Increase the distance between the equipment and the receiver Connect the equipment to a different power outlet other than the one where receiver is connected Consult a certified television or radio technician A. Installing a 3. 5" SATA hard drive SATA hard drive TECHNICAL SUPPORT Phone: 408-453-6212 Hours: 8:30 am - 6:00 pm PST Email: http://www. addonics. com/support/query/ Slide in the 3. 5" SATA hard drive and secure on the tray using screws. B. Installing a 3. 5" IDE hard drive The Z USB3. 0 / eSATA combo drive enclosure comes with an IDE to SATA converter. 40-pin IDE Connector 4. At the other end of the Y-power cable is the 4-pin floppy power connector which you connect to the converter. Now connect the SATA cable to the SATA port on the converter. SATA Port 4-Pin Floppy Power 5. Note: It is required to set up the IDE hard drive you are connecting to the converter as a MASTER device. Then connect the SATA cable to the SATA port on the IDE to SATA converter SATA board 4-pin Molex Power Connector ADSAIDE IDE to SATA converter 40-pin IDE Connector Master or Slave Jumper Settings 2. [. . . ] Step 3 Use the enclosed screws to secure the hard drive to the tray. Screw holes [. . . ]