User manual ADDONICS HDUSI3TDR

[. . . ] ADDONICS TECHNOLOGIES Model: HDUSI3TDR Note: Make sure that the capacity of the target hard disk is equal or larger than the source hard disk. [. . . ] The Duplicator Panel There are four buttons and an LCD on the panel of HDD Duplicator. Duplicating a drive When the duplicator powers on, it initializes and goes through the steps below Duplicator Panel Source Drive Bay Target Drive Bay1 Target Drive Bay2 Target Drive Bay3 Power Switch Shows the firmware version Initialize SDRAM's status. . Detect Drives' status. Shows the first function: Copy HDD copies data directly from the source hard disk to the target hard disk. For installing a hard drive on the various enclosures that come with the HDD duplicator, refer to the bundled enclosure installation guides. Step 1 Once the hard drive is installed on the drive enclosure, slide in the Source drive into the drive bay. Push down the handle and using the key provided, turn the key lock to the Lock position. Push down the handle and using the key provided, turn the key lock to the Lock position. Connecting the power cable and powering on Connect the power cord provided from the wall outlet to the back of the tower. The complete user manual of the HDD Duplicator Panel can found in the Driver Disk under User Guides or can be downloaded from http://www. addonics. com/support/user_guides/ Technical Support Contact Information Phone: 408-573-8580 Fax: 408-573-8588 Email: http://www. addonics. com/sales/query/ Internet: http://www. addonics. com TECHNICAL SUPPORT Phone: 408-453-6212 Hours: 8:30 am - 6:00 pm PST Email: http://www. addonics. com/support/query/ Press ENT button to begin copy. [. . . ] Once the copying process is complete the LCD will display the following results. c. [. . . ]