User manual ADDONICS HDUSI325AES

[. . . ] Calling the technical support staff without all the proper information can be both time consuming and frustrating. Here are some tips to help you out: Contact Information Phone: 408-573-8580 Fax: 408-573-8588 Email: http://www. addonics. com/sales/query/ Internet: http://www. addonics. com TECHNICAL SUPPORT Phone: 408-453-6212 Hours: 8:30 am - 6:00 pm PST Email: http://www. addonics. com/support/query/ 1 Copy HDD Copy HDD copies data directly from the source hard disk to the target hard disk. Make sure that the capacity of the target hard disk is equal or larger than the source hard disk. [. . . ] Press ENT to change the Language settings. Press ENT to begin scan. The LCD will display the following info 6. 2 Copy Size This option is used to specify the size of the source hard disk for simplifying further copying operations. Press ENT and the LCD will display the options menu. By default it is set to On, use the Up and Down arrow keys to choose Off. Press ENT and the LCD will display a detailed list of options as shown below 6. 6 Button Sound Press ENT and the LCD will display the following info. Use the Up and Down arrow keys to choose whether button sound is on or off. The system will offer their corresponding percentages so the user can specify the amount to copy from the source hard disk. 6. 3 Startup Menu This option allows you to set an option other than "Setup" to be displayed as the first available option on the menu every time you start the system. Press ENT and the LCD will display each hard disk' information in order as shown below. Press ENT then use the Up and Down arrow keys to choose other options. 6. 4 Auto Compare This option automatically compares the source hard disk with the target hard disk after a copy operation is completed. 7 USB Mode Note: Though this is an active menu, we recommend you not to use this since no USB connection is present for this HDD Duplicator. Press ENT and the LCD will display the corresponding information as shown below. 6. 7 Device Info This option is used to display the details of all hard disks connected to the copy controller. Press ENT to access option. Use the Up and Down arrow keys to choose On. 6. 5 Copy with detect This option is used to detect any newly connected DOM devices (can be used as hard disk and supports hot swapping) before starting a copy process. Use the Down arrow to select YES then press ENT again to switch to USB Mode. The LCD will display the following info. Now press ENT to switch to stand-alone mode. The LCD will display the following info. Appendix A LCD Messages Press ENT and the LCD will display the corresponding info. The controller will prompt you to restart the device. Basic Troubleshooting 6. 1 LCD If the LCD display is blank after the device is turned on, check that the power cable is properly connected and that the power supply is on. 6. 2 Error Message When the system is running a copy operation or hardware diagnostics then operation was manually terminated by pressing ESC, an error message will be shown by the LCD. This may lead to an illegal operation and cause the device to stop reminding. [. . . ] No Valid HDD!. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Partition Damage. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . The partition is damaged. Select HD First!. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]