User manual ADDONICS HDUSI325

[. . . ] The Duplicator Panel There are four buttons and an LCD on the panel of HDD Duplicator. [. . . ] To do this, navigate to: 6. Setup > 6. 2Copy Size and use the button arrows to decrease the drive size of the source drive by increments of 1%. Duplicator Panel Power Switch Source Drive Bay Target Drive Bay IV. Duplicating a drive When the duplicator powers on, it initializes and goes through the steps below Shows the firmware version Initialize SDRAM's status. . Detect Drives' status. For installing a hard drive on the various enclosures that come with the HDD duplicator, refer to the bundled enclosure installation guides. Step 1 Once the hard drive is installed on the drive enclosure, slide in the Source drive into the drive bay. Push down the handle and using the key provided, turn the key lock to the Lock position. Push down the handle and using the key provided, turn the key lock to the Lock position. Connecting the power cable and powering on Connect the power cord provided from the wall outlet to the back of the tower. Push the auxiliary switch button to turn on the HDD duplicator. Shows the first function: Copy HDD copies data directly from the source hard disk to the target hard disk. [. . . ] Once the copying process is complete the LCD will display the following results. c. The complete user manual of the HDD Duplicator Panel can found in the Driver Disk under User Guides or can be downloaded from http://www. addonics. com/support/user_guides/ TECHNICAL SUPPORT Phone: 408-453-6212 Hours: 8:30 am - 6:00 pm PST Email: http://www. addonics. com/support/query/ [. . . ]