User manual ADDONICS HDUSAS

[. . . ] HDD Duplicator Overview Note: Make sure that the capacity of the target hard disk is equal or larger than the source hard disk. Source SATA port 4-pin floppy power connector Destination SATA port III. [. . . ] Step 3 Connect a 4-pin floppy power cable from the power supply to the 4-pin floppy power connector on the HDD Duplicator. Sample Connection Diagram Detect Drives' status. Shows the first function: Copy HDD. Copy HDD copies data directly from the source hard disk to the target hard disk. The system will auto-detect the hard disks and show the following info on the LCD. Destination drive (black port on Duplicator console) The LCD will show the following info during the copying process: remaining time, completed percentage. The copy speed, capacity and time will vary depending on the source hard disk. [. . . ] Once the copying process is complete the LCD will display the following results. The complete user manual of the HDD Duplicator Panel can found in the Driver Disk under User Guides or can be downloaded from http://www. addonics. com/support/user_guides/ Source drive (blue port on Duplicator console) Technical Support Contact Information Phone: 408-573-8580 Fax: 408-573-8588 Email: http://www. addonics. com/sales/query/ Internet: http://www. addonics. com TECHNICAL SUPPORT Phone: 408-453-6212 Hours: 8:30 am - 6:00 pm PST Email: http://www. addonics. com/support/query/ II. The Duplicator Panel There are four buttons and an LCD on the panel of HDD Duplicator. [. . . ]