User manual ADDONICS HDUS5325DX

[. . . ] ADDONICS TECHNOLOGIES Model: HDUS5325DX Note: Make sure that the capacity of the target hard disk is equal or larger than the source hard disk. [. . . ] The Duplicator Panel There are four buttons and an LCD on the panel of HDD Duplicator. 5 ­ it is used to cancel a function. Duplicator Panel Source Drive Bay IV. Duplicating a drive When the duplicator powers on, it initializes and goes through the steps below Shows the firmware version Initialize SDRAM's status. . Target Drive Bay1 Target Drive Bay2 Target Drive Bay3 Target Drive Bay4 Target Drive Bay5 Power Switch Detect Drives' status. Shows the first function: Step 1 Open the source drive door and slide in the 3. 5" SATA hard disk Source drive into the drive bay. Close the front panel and using the key provided, turn the key lock to the Lock position. Step 2 Open the target drive door(s) and slide in the 3. 5" SATA hard disk Target drive(s) into the drive bay. Close the front panel and using the key provided, turn the key lock to the Lock position. This will secure the drive and turn on the power to the hard drive. Copy HDD copies data directly from the source hard disk to the target hard disk. The system will auto-detect the hard disks and show the following info on the LCD. The LCD will show the following info during the copying process: remaining time, completed percentage. [. . . ] Technical Support Contact Information Phone: 408-573-8580 Fax: 408-573-8588 Email: http://www. addonics. com/sales/query/ Internet: http://www. addonics. com TECHNICAL SUPPORT Phone: 408-453-6212 Hours: 8:30 am - 6:00 pm PST Email: http://www. addonics. com/support/query/ c. [. . . ]