User manual ADDONICS HDUS525

[. . . ] Duplicating a drive When the duplicator powers on, it initializes and goes through the steps below Shows the firmware version Note: Make sure that the capacities of the target hard disks are equal or larger than the source hard disk. [. . . ] To do this, navigate to: 8. Setup > 8. 2Copy Size and use the button arrows to decrease the drive size of the source drive by increments of 1%. Initialize SDRAM's status. . Detect Drives' status. Shows the first function: Copy HDD. Duplicator Panel Source Drive Bay Target Drive Bays Copy HDD copies data directly from the source hard disk to the target hard disk. The system will auto-detect the hard disks and show the following info on the LCD. Power Switch Step 1 Push the slide switch of the drive door gently from left to right to open the source drive door (top bay) and slide in the 2. 5" SATA hard disk Source drive into the drive bay. Step 2 Push the slide switch of the drive door gently from left to right to open the target drive door and slide in the 2. 5" SATA hard disk Target drive into the drive bay. Connecting the power cable and powering on Connect the power cord provided from the wall outlet to the back of the HDD Duplicator. Push the button to turn on the HDD duplicator. The LCD will show the following info during the copying process: remaining time, completed percentage. The copy speed, capacity and time will vary depending on the source hard disk. [. . . ] Technical Support Contact Information Phone: 408-573-8580 Fax: 408-573-8588 Email: http://www. addonics. com/sales/query/ Internet: http://www. addonics. com TECHNICAL SUPPORT Phone: 408-453-6212 Hours: 8:30 am - 6:00 pm PST Email: http://www. addonics. com/support/query/ [. . . ]