User manual ADDONICS HDUS35

[. . . ] Duplicating a drive When the duplicator powers on, it initializes and goes through the steps below Shows the firmware version Note: Make sure that the capacity of the target hard disk is equal or larger than the source hard disk. [. . . ] The system will auto-detect the hard disks and show the following info on the LCD. Step 1 Open the source drive door and slide in the 3. 5" SATA hard disk Source drive into the drive bay. Close the front panel and using the key provided, turn the key lock to the Lock position. Step 2 Open the target drive door and slide in the 3. 5" SATA hard disk Target drive into the drive bay. Close the front panel and using the key provided, turn the key lock to the Lock position. This will secure the drive and turn on the power to the hard drive. The LCD will show the following info during the copying process: remaining time, completed percentage. The copy speed, capacity and time will vary depending on the source hard disk. Once the copying process is complete the LCD will display the following results. II. b. Connecting the power cable and powering on Connect the power cord provided from the wall outlet to the back of the HDD Duplicator. [. . . ] Technical Support Contact Information Phone: 408-573-8580 Fax: 408-573-8588 Email: http://www. addonics. com/sales/query/ Internet: http://www. addonics. com TECHNICAL SUPPORT Phone: 408-453-6212 Hours: 8:30 am - 6:00 pm PST Email: http://www. addonics. com/support/query/ [. . . ]