User manual ADDONICS CPD256U

[. . . ] Installing drives into the Pocket Cipher IMPORTANT There is no back door for the Pocket Cipher encrypted hard drive if the Cipher keys are lost or stolen. Cipher key Check to make sure you have the correct version of the Cipher key. [. . . ] There will be no partition or any hint to indicate that the drive contains encrypted data. The same holds true if a hard drive already has data on it is installed into the Pocket Cipher. The computer detects the hard drive as a brand new drive or a drive that is unallocated. Once you proceed to partition the drive, the data that was on the hard drive will be erased and cannot be recovered. Install 2. 5" SATA hard drive and secure it with the screws provided. Slide back the cover. Top Cover Power and drive activity LED Secure the enclosure by tightening the screws provided. mini USB2. 0 port Cipher key label Cipher keyhole Screw hole Screw hole ADDONICS TECHNOLOGIES Model: CPD256U II. a. Connections on the Pocket Cipher Insert the AES 256-bit cipher key into cipher keyhole located at the front panel of Pocket Cipher. b. Connect the mini USB2. 0 cable to the mini USB port on the Pocket Cipher and the other end of the cable to the USB2. 0 port of the computer. Go to the operating system's management utility to verify new hard drive detection. Insert the AES 256-bit cipher key into cipher keyhole located at the front panel of Pocket Cipher. Connect the mini USB2. 0 cable to the mini USB port on the Pocket Cipher and the other end of the cable to the USB2. 0 port of the computer. If not, disconnect the USB cable and reinsert the cipher key then connect back the mini USB cable. [. . . ] e. f. Best Practice: Create a label to identify the SATA hard drive and the associated Cipher key used. TECHNICAL SUPPORT Phone: 408-453-6212 Hours: 8:30 am - 6:00 pm PST Email: http://www. addonics. com/support/query/ [. . . ]