User manual ADDONICS CDSC-02 INSTALLATION

[. . . ] ADDONICS TECHNOLOGIES Model: CDSC-02 Installation Guide PIN authentication keypad II. Insert the smartcard with the contacts facing down into the Cipher Drive SC before inserting the mini USB2. 0 or Firewire 400/800 into the corresponding port on the Cipher Drive SC. Note. You may choose to connect the device either via Firewire or USB2. 0. Smart Card slot Top cover latch 2. Insert the USB2. 0 or Firewire 800 (or 400) connector to your computer's corresponding port. [. . . ] At the end of PIN entry, press the Enter button. CAUTION: Smart Card security and administrative functions must be performed carefully as they cause changes in smart cards and associated PINs. Please read the following instructions carefully and follow them when performing administrative functions. PIN Change Note: Please note that smart card PINs are specific so changing the PIN with one smart card does NOT automatically change the PIN of another. It is recommended that you change the default factory PIN to another one that only you know. The Status LED blinks twice to notify that you may press the confirmed new PIN. Upon a successful PIN change, Cipher Drive SC will proceed to connect the drive. At the same time, the Status LED will blink three times and there will be two `beep' sounds upon a successful PIN change. If not, the Error LED will blink continuously. Note: If an incorrect PIN is entered, the Error LED will blink continuously. If you have mistyped your PIN, press the Esc key at any time to restart the entire authentication process. You will be LOCKED-OUT of your smart card after 8 incorrect PIN attempts. V. Setting up the drive After you have successfully authenticated yourself to Cipher Drive SC, drive access will be granted. The connected drive will then present itself to the operating system as a removable drive. Once the drive appears in your operating system, you may proceed to use it like a normal hard drive. To set up a new hard drive, you have to partition and format it. As with any other storage solution, please ensure that you make regular backups of your data to protect against possible data loss. Note: VI. Disconnecting the drive To disconnect Cipher Drive SC, follow your operating system's proper device removal process. Cipher Drive SC only accepts 8-digit PINs. If a shorter or longer PIN is entered, the Error LED will blink continuously. Please be aware that you may have different PINs for each of the two included smart cards. Again, you will be locked out of your smart card after 8 incorrect PIN attempts. ADDONICS TECHNOLOGIES Model: CDSC-02 B. Administrative Mode You may enter Administrative mode with Cipher Drive SC. [. . . ] The Status LED blinks twice to notify that you may press the new Admin PIN. The Status LED blinks twice to notify that you may press the confirmed new Admin PIN. The Status LED will blink three times and there will be two `beep' sounds if the PIN change is successful. TECHNICAL SUPPORT Email: Internet: http://www. addonics. com/sales/query/ http://www. addonics. com If you have mistyped your PIN, press the Esc key at any time to restart the entire authentication process. Technical Support (8:30 am to 6:00 pm PST) Phone: 408 453-6212 Email: http://www. addonics. com/support/query/ [. . . ]