User manual ACTIONTEC WIRELESS N USB ADAPTER

[. . . ] Creative Solutions for the Digital LifeTM How to install The Wireless N USB Adapter Step 1 Plug the adapter into an 2 OPEN USB Port on your computer. The following steps are only for those users whose wireless modem, router or access point does not have a WPS button on it. Step Step A screen will appear on your computer (Vista users will need to Click "Run Setup. exe"). Wait until the files are loaded. Right click on the "Wireless Icon" on the bottom righthand corner of your screen. [. . . ] Make sure that you enter the same key or password that is being used by your wireless modem, router or access point. Then click "Connect" . Step 4 Go to your wireless modem, Step router or access point and press the WPS button for at least two full seconds. Make sure to press the button within 120 seconds (2 minutes). 5c Once you see the screen "Successfully connected to . . . " click"Close" On the computer with the USB Wireless , . If you can, you have successfully installed the Wireless N USB Adapter. Step 4a Step 4b You should see a "WPS Authentication" screen on your computer/monitor. If you do not see this screen, make sure that the Wireless Adapter is completely plugged into the USB Port on your computer. Wait until the screen says "Authentication succeeded" Now, try to surf . [. . . ] Product photo may differ from actual product, however functionality remains as stated above. [. . . ]