User manual ACT ACTLAN INTERFACE CONFIGURATION

[. . . ] ACTLAN Interface Configuration LAN/WAN Connections for 25 Way male Connector 7 32 10BASE-T 9-30v serial Max cable length is 5m using standard alarm cable or 30m using twin twisted-pair (use 0V in each pair) NETWORK A B 0V A B 0V DB25 Male (Rear View) Connections for Direct Connect diagnositc status 1. [. . . ] Connect a PC directly to the ACTLAN and run HyperTerminal at 9600 baud, no parity, 1 stop. Power up the ACTLAN and immediately hit 3 lowercase "x" (xxx). If the ACT controllers are on a different LAN segment to the ACTWin Pro PC, then a Gateway Address is required. Check with the network administrator for the IP address of the router. Set up the following parameters as follows: Baud Rate 9600 I/F Mode Flow 00 Port Connect Mode C0 Disconnect Mode 00 Flush Mode 80 Pack Control 00 Remote IP Address none 12. Finally test the setup by connecting to the IP address using a Web browser or 'Pinging'. From ACTWin Pro, enter the new IP address into the location manager for the site. TCP/IP Configuration 4C for Direct 18-00026 Issue 4 Unit 8 IDA Business Park, Whitestown, Tallaght, Dublin 24, Ireland. E-mail: sales@actrl. com Web: www. actrl. com Telephone: 353 1 Telephone: 353 1 466 2570 UK Lo-Call 0845-300 5204 Fax: 353 1 452 0427 www. accesscontrol. ie E-mail: sales@accesscontrol. ie ACT LAN Manufacturing Instructions Instructions Issue 3 - 8 March 2004 1. [. . . ] 1 452sales@actrl. com Web:sales@accesscontrol. ie Web: www. accesscontrol. ie 466 2570. [. . . ]