User manual ACT ACT1020 WIRING FOR ENTRYEXIT
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual ACT ACT1020. We hope that this ACT ACT1020 user guide will be useful to you.
 |
ACT ACT1020 WIRING FOR ENTRYEXIT: Download the complete user guide (192 Ko) |
Manual abstract: user guide ACT ACT1020WIRING FOR ENTRYEXIT
Detailed instructions for use are in the User's Guide.
[. . . ] [. . . ] Readers should be a maximum of 30m from the controller when powered from +5V and a maximum of 100m when powered from +12V.
Wire both readers in parallel but leave the SENSE line on the Exit reader unconnected.
The +5V reader supply on ACT controllers is normally rated at 100mA. Note however that readers from other manufacturers may need to be powered separately if their current requirements exceed this or if they require 12V.
Card/Prox Reader
For Wiegand readers . Wire both readers in parallel but connect D0 line of the exit reader into the SENSE line on the controller, leave the SENSE line on the Exit reader unconnected.
Reader Specification Voltage: Current: Operating Temperature: Media: Read Range: 5-12V DC 15 mA standby, 25 mA maximum -10 degres C to +55 degrees C HID Proximity cards and key fobs 10 cm with prox card 11
U nit 8 Tallaght B usiness Centre, W hitestown, Tallaght, Dublin 24, Ireland. [. . . ] [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE ACT ACT1020
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual ACT ACT1020 will begin.