User manual ACT ACT10 DIGITAL KEYPAD

[. . . ] Always remember to place the supplied Varistor across the terminals of the door strike coil to protect the relay contacts. An external relay isolated electrically from the ACT10 should be used for this purpose. Don't forget to change the programming code to something known only to yourself. Note: The keypad may be returned to its factory default condition at any time by entering the programming mode and pressing the % three times. [. . . ] Interlock When set, two or more keypads may be interlocked so that only one controlled door may be open at any one time. The interlock output is active whenever the relay is active or when the door contact is open. When the interlock input is active the release button and all codes are inactive, and the red indicator flashes. The interlock outputs and inputs of any number of keypads may be combined on a single wire. Six Digit Codes When set, all user codes and the programming codes are six digits long. The default user one code becomes 123456 and the default programmer code becomes 999999. Twin Codes When set, two different codes must be entered within 15 seconds in order to open the door. The outputs activated are those which have been programmed for the first code to be entered. Door Forced Alarm When set, the buzzer output is activated if the door contact opens when a valid code has not been entered. Group Disable When set, the top five user codes (5-9) are inactive any time the interlock input is activated. Auto Backlighting When set, the keypad illumination is normally off, but will switch on in response to any key being pressed or while in programming mode. Door Ajar Alarm When set, and the door contact has been open for longer than the time programmed into the door ajar timer, the built­in and external buzzers sound intermittently. The buzzers may be silenced by closing the door and entering a valid code. Guest Button When set, (default) and when the # key on the keypad is pressed, the buzzer output is activated for the duration programmed in the guest buzzer timer. Fire Alarm Override When set, the relay is held active whenever the interlock input is active, and the green indicator will flash. This is useful for following a fire alarm system to override controlled doors. [. . . ] Always Place Varistor Across All Lock Terminals +V Guest Buzzer 0123456789 N/C C N/O Volt - Free Tamper Contacts Door Release Button for Door 2 This diagram shows revision (3. 1) of the ACT10 This unit may be used to control 2 doors as illustrated in the diagram above. Connections and programming for this unit are exactly the same as for previous versions, however the connector positions have changed as shown in the above diagram. Unit 8 IDA Business Park, Whitestown, Tallaght, Dublin 24, Ireland. E-mail: sales@accesscontrol. ie Web: www. accesscontrol. ie RELAY DOOR 2 +V 0V Power Supply 12-24V ACDC Door 2 ACT 10 Digital Keypad Guides to outdoor installation in exposed areas. Access denied Standby Access Granted · Do not apply silicone to the bottom of the keypad as this will block the air vents and trap any water which may enter the keypad. [. . . ]