User manual ACER K242HL

[. . . ] 1 Important Information GB For your Condenser dryer to operate efficiently, you must follow the regular maintenance schedule shown below: Fluff Filter. Refit the filter - NEVER run the dryer without the filter in position. Failure to clean the filter after EVERY drying cycle will affect the drying performance of your machine. - It will take longer to dry and as a result will use more electricity during drying. [. . . ] The programme time will vary dependant on the exact make up of the load. EXTRA PROGRAMMES - Programmes Table Programme Options available Dryness Levels available (default highlighted ✓ ) Hanger Dry Plus Cupboard Dry Crease Care Delay Timer Hanger Dry Sensor Dry Extra Care Damp Dry High Heat 13 14 15 Heat & Enjoy Easy Iron Refresh ✗ ✗ ✗ ✗ ✗ ✗ ✗ ✗ ✗ ✗ ✗ ✗ ● An Automatic programme An Automatic programme An Automatic programme ● ● Heat & Enjoy This programme helps to heat towels & bathrobes for a warm sensation after a bath or shower. The cycle heats clothes to 37°C (Body Temperature) and runs at this temperature for a maximum of 4 hours or until you stop the cycle by opening the door. Easy Iron Programme ‘Easy Iron’ is a short 10 minute programme (8 minutes of heat followed by a 2 minute cool tumble period) which fluffs the fibres of clothing that have been left in the same position/location for an extended period of time. €Easy Iron’ is not a drying programme and should not be used for wet articles of clothing. These numbers refer to the dry weight: Fabric Maximum load Cotton and Cotton mixtures 2. Unload the dryer immediately after the end of the programme, hang, fold or iron the articles and put them away in the closet. The ‘Easy Iron’ effect varies from one fabric to the next. It works well on traditional fabrics like Cotton or Cotton mix, and less well on acrylic fibres and on materials such as Tencel®. €Refresh’ is not a drying programme and should not be used for wet articles of clothing. — It can be used on any load size but is more effective on smaller loads. You must empty the water container and restart the dryer or the clothes will not dry. After re-starting the dryer, the light will take a few seconds to go out. To avoid this always empty the water container each time you use the dryer (see Maintenance). — ● Extra Care This Anti-Ageing function for Cottons helps to maintain the brightness of your laundry for a long time, thanks to the correct drum rotation (reduced in the last part of the cycle) and the correct temperature. Note: It cannot be used with the ‘Extra Dry’, ‘Cupboard Dry’ and ‘Light Dry’ dryness levels. Door Opening Opening the door (or pressing the Start/Pause button) during a programme will stop the dryer and have the following effects: Note: The Start/Pause light flashes Amber during the Post Care phase of a programme. The progress lights will change to show the current status and the Start/Pause light will stop flashing and turn green. — During the Post Creasecare phase of a drying programme, the programme will finish. Pressing the Start/Pause button will re-start a new programme at the beginning. — Changing the programmes knob will select a new programme and the Start/Pause light will flash green. You can use this to select the Refresh programme to cool the clothes, if you find them dry enough. [. . . ] The PROGRAMMES knob has not been set properly (see Start and Programmes). The START/PAUSE button has not been pressed (see Start and Programmes). The temperature setting is not ideal for the type of fabric you are drying (see Start and Programmes, and see Laundry). The correct drying time has not been selected for the load (see Laundry). [. . . ]