User manual ABRIVO VB-44240A

[. . . ] VB-44240A 900 MHz Cordless Telephone Installation and Users Guide December, 2004 The contents of this manual are subject to change without notice and do not constitute a commitment on the part of Abrivo Communications. However, due to ongoing product improvements and revisions, Abrivo cannot guarantee the accuracy of printed material after the date of publication nor can it accept responsibility for errors or omissions. The software and hardware described in this document may be used or copied only in accordance with the terms of the license pertaining to said software or hardware. Reproduction, publication, or duplication of this manual, or any part thereof, in any manner, mechanically, electronically, or photographically, is prohibited without permission of the Abrivo Communications. Table of Contents Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] A battery low alert tonesounds once every 15 seconds for three minutes. · Talk mode: The Battery Low icon appears, and the battery low alert tone soundsonce every three seconds until the conversation ends. appears if the ringer is turned off with the R/VOL switch. 4 Message Waiting Indication The Message icon is displayed when a message is waiting. If the message is longer than 32 characters, the message is displayed on two "pages". The display switches between pages at 1. 5 second intervals. Base Station Features Number 1 2 3 4 5 Feature Cordless Button Cordless LED Status LED Desk LED Desk Button 5 OPTIONAL HEADSET (VB-44249HS) The optional Headset provides a "Hands-Free" Option for the 900 MHz phone. With the Headset installed, you can use the Belt Clip to carry the handset, and conduct a conversation using the Head Set. To install the optional Headset, open the cover over the Headset Jack and plug the Headset in. Operation of the 900 MHz phone using the Headset is exactly the same as using the handset. However, you will hear through the Headset earphone, and talk through the Headset microphone. The handset earphone and microphone (mouthpiece) are disconnected when the headset is plugged in. CHARGING UNIT (EXP9785) The unique design of your 900 MHz phone allows you to place the handset in the charging unit with or without the Belt Clip attached. The Battery Packs can be recharged either in or out of the handset. 6 Installing the 900 MHz Cordless Telephone The Abrivo 900 MHz Cordless phone is installed with your existing key telephone and DBS series PBX as shown in the following illustration: 1. SELECTING THE INSTALLATION LOCATION The base station can be placed on a desk or tabletop near a standard 120V AC outlet and telephone line jack. The base station can also be mounted on a standard AT&T or GTE wall plate, or directly on a wall, using the Wall Mount Adapter. Keep the base station and handset away from excessive heat and humidity, and from sources of electrical noise (motors, transformers, fluorescent lighting, or computers). Mount the base station and your key telephone at least three to four feet apart to avoid noise from the key telephone speaker. If you are installing multiple base units, place them at least five feet apart. 2. CONNECTING THE TELEPHONE CORDS The base station for your 900 MHz phone must be connected to the Panasonic PBX. Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the network interface. 7 Connecting the Base Station to the PBX and Key Telephone 3. Route the power cord where it will not create a trip hazard, or where it could become chafed and create a fire or other electrical hazards. 3. 1 Applying Power to the Base Station Use only the supplied AC Adapter (EXP9704). 3. 2 Applying Power to the Charging Unit Use only the supplied AC Adapter (AD970). 8 4. Remove the battery cover by pressing the latch and sliding the cover down and off of thehandset. 2. Place the cover and slide thecover up until it latches intothe handset. 5. CHARGING THE HANDSET BATTERY (FIRST TIME) The Rechargeable Nickel-Cadmium Battery must be fully charged before using your 900 MHz phone for the first time. If the CHARGE light doesn't light, check to see that the AC Adapter is plugged in, and that the handset is making good contact with the charging unit charging contacts. [. . . ] Charge the battery without interruption for 5 hours. CLEANING HANDSET & CHARGING UNIT CONTACTS To maintain a good charge, it is important to clean all charging contacts on the handset and charging unit about once a month. CHARGING A SPARE BATTERY The Charger Unit of your 900 MHz phone is equipped to charge a spare battery with or without the handset in the front slot. Slide the (optional) spare battery into the second slot in the charging unit until the retaining clip snaps over the top of the battery. If the BATT CHARGE indicator doesn't light, check to see that the AC Adapter is plugged in, and that the battery is making good contact with the charging unit charging contacts. [. . . ]