User manual ABIT SL6

[. . . ] Copyright and Warranty Notice The information in this document is subject to change without notice and does not represent a commitment on part of the vendor, who assumes no liability or responsibility for any errors that may appear in this manual. No warranty or representation, either expressed or implied, is made with respect to the quality, accuracy or fitness for any particular part of this document. In no event shall the manufacturer be liable for direct, indirect, special, incidental or consequential damages arising from any defect or error in this manual or product. Product names appearing in this manual are for identification purpose only and trademarks and product names or brand names appearing in this document are the property of their respective owners. [. . . ] You can enable or disable the onboard FDD controller. Onboard Serial Port 1: This is used to specify the I/O address and IRQ of Serial Port 1. Six options are available: Disabled ) 3F8/IRQ4 ) 2F8/IRQ3 ) 3E8/IRQ4 ) 2E8/IRQ3 ) AUTO. The default setting is 3F8/IRQ4. Onboard Serial Port 2: This is used to specify the I/O address and IRQ of Serial Port 1. Six options are available: Disabled ) 3F8/IRQ4 ) 2F8/IRQ3 ) 3E8/IRQ4 ) 2E8/IRQ3 ) AUTO. Onboard IR Function: Three options are available: IrDA (HPSIR) mode ) ASK IR (Amplitude Shift Keyed IR) mode ) Normal. RxD , TxD Active: Four options are available: Hi, Hi ) Hi, Lo ) Lo, Hi ) Lo, Lo. IR Transmission Delay: Two options are available: Enabled and Disabled. Set IR transmission delays 4 character-time (40 bit-time) when SIR is changed from RX mode to TX mode. Refer to your IR KIT user's guide to find out which setting is correct. The default setting is IRUser's Manual 3-30 Chapter3 Rx2Tx2. If you choose RxD2, TxD2, your motherboard must support a COM port IR KIT connection. Otherwise, you can only choose the IR-Rx2Tx2 to use the IR header on your motherboard to connect your IR KIT. Please use the default setting. Onboard Parallel Port: Sets the I/O address and IRQ of the onboard parallel port. Parallel Port Mode: Four options are available: SPP ) EPP ) ECP ) ECP+EPP. When the mode selected for the parallel port mode is EPP, the two EPP version options are available. When the mode selected for the parallel port mode is ECP, the DMA channel selected can be Channel 1 or Channel 3. PWRON After PWR-Fail: This setting lets you set the system action after a power failure. The default setting is Off. Game Port Address: Three options are available: Disabled ) 201 ) 209. This item sets the address of the onboard game port connector. Midi Port Address: Four options are available: Disabled ) 330 ) 300 ) 290. This item sets the address of the onboard midi port connector. SL6 BIOS Setup 3-31 Midi Port IRQ: Two options are available: 5 ) 10. If you choose disable the Midi Port Address, then this field is not available. Note If you buy the audio adapter and want to replace the use of onboard audio solution, you have to disable three items in BIOS. These three items are: AC 97 Audio set to Disabled Game Port Address set to Disabled Midi Port Address set to Disabled User's Manual 3-32 Chapter3 3-6. [. . . ] Your ABIT authorized distributor should be able to provide the fastest solution to your technical problem. We sell our products through distributors who sell to resellers and stores. Your reseller should be very familiar with your system configuration and should be able to solve your problem much more efficiently than we could. After all, your reseller regards you as an important customer who may purchase more products and who can urge your friends to buy from him or her as well. [. . . ]