User manual ABIT SE6

[. . . ] Copyright and Warranty Notice The information in this document is subject to change without notice and does not represent a commitment on part of the vendor, who assumes no liability or responsibility for any errors that may appear in this manual. No warranty or representation, either expressed or implied, is made with respect to the quality, accuracy or fitness for any particular part of this document. In no event shall the manufacturer be liable for direct, indirect, special, incidental or consequential damages arising from any defect or error in this manual or product. Product names appearing in this manual are for identification purpose only and trademarks and product names or brand names appearing in this document are the property of their respective owners. [. . . ] Onboard Display Cache Setting: When using the onboard VGA function, you had best use the default setting. RAS-to-CAS Override: Two options are available: by CAS# LT and Override (2). This item controls RAS# active to Protegra, and refresh to RAS# active delay (in local memory area). This item controls RAS# precharge (in local memory area). User's Manual 3-14 Chapter3 3-5. Integrated Peripherals In this menu, you can change the onboard I/O device, I/O port address and other hardware settings. Figure 3-7. Integrated Peripherals Menu Screen Onboard IDE-1 Controller: The onboard IDE 1 controller can be set as Enabled or Disabled. The integrated peripheral controller contains an IDE interface with support for two IDE channels. If you choose Disabled, it will effect the settings of four items not available. For example, if you disabled the Onboard IDE-1 Controller, you will also disable the Master/Slave Drive PIO Mode and Master/Slave Drive Ultra DMA. Master/Slave Drive PIO Mode: Six options are available: Auto ) Mode 0 ) Mode 1 ) Mode 2 ) Mode 3 ) Mode 4. The five IDE PIO (Programmed Input/Output) items let you set a PIO mode (0-4) for each of the four IDE devices that the onboard IDE interface supports. In Auto mode (default setting), the system automatically determines the best mode for each device. Master/Slave Drive Ultra DMA: Two options are available: Auto and Disabled. Ultra DMA is a DMA data transfer protocol that utilizes ATA commands and the ATA bus to allow DMA commands to transfer data at a maximum burst rate of 100 MB/sec. Ultra DMA/33 or Ultra DMA/66/100 implementation is possible only if your IDE hard drive supports it and the operating environment includes a DMA driver (Windows® 95 OSR2 / 98 / NT / 2000 or a thirdparty IDE bus master driver). SE6 BIOS Setup 3-15 If your hard drive and your system software both support Ultra DMA, select Auto to enable BIOS support. Auto: Disabled: If you encounter a problem in using Ultra DMA devices, you can try to disable this item. Onboard IDE-2 Controller: Description is same as the Onboard IDE-1 Controller. This motherboard provides two Universal Serial Bus (USB) ports, thus supporting USB devices. If you don't want to use USB devices, set it to Disabled, then the item USB Keyboard Support & USB Mouse Support will also be disabled. If you want to use USB keyboard in DOS environment, please set it to BIOS. If you want to use USB mouse in DOS environment, please set it to BIOS. Init Display First: Two options are available: PCI Slot and Onboard/AGP. [. . . ] Your ABIT authorized distributor should be able to provide the fastest solution to your technical problem. We sell our products through distributors who sell to resellers and stores. Your reseller should be very familiar with your system configuration and should be able to solve your problem much more efficiently than we could. After all, your reseller regards you as an important customer who may purchase more products and who can urge your friends to buy from him or her as well. [. . . ]