User manual ABIT KV8-MAX3

[. . . ] KV8-MAX3 Socket 754 System Board User's Manual 4200-0389-13 Rev. 1. 02 Copyright and Warranty Notice The information in this document is subject to change without notice and does not represent a commitment on part of the vendor, who assumes no liability or responsibility for any errors that may appear in this manual. No warranty or representation, either expressed or implied, is made with respect to the quality, accuracy or fitness for any particular part of this document. In no event shall the manufacturer be liable for direct, indirect, special, incidental or consequential damages arising from any defect or error in this manual or product. [. . . ] First Boot Device / Second Boot Device / Third Boot Device / Boot Other Device: Select the drive to boot first, second and third in the [First Boot Device], [Second Boot Device], and [Third Boot Device] items respectively. The BIOS will boot the operating system according to the sequence of the drive selected. Set [Boot Other Device] to [Enabled] if you wish to boot from another device other than these three items. Boot Up Floppy Seek: When set to [Enabled], the BIOS will check whether the floppy disk drive is installed or not. Boot Up NumLock Status: This item determines the default state of the numeric keypad at system booting up. [Off]: The numeric keypad functions as arrow keys. KV8-MAX3 BIOS Setup 3-9 Security Option: This item determines when the system will prompt for password - every time the system boots or only when enters the BIOS setup. If you forget the password, you will have to open the computer case and clear all information in the CMOS before you can start up the system. MPS Version Ctrl For OS: This item specifies which version of MPS (Multi-Processor Specification) this motherboard will use. If you use an older OS for dual processor executing, please set this option to 1. 1. Report No FDD For OS: When set to [Enabled], this item allows you to run some older operating system without floppy disk drive. Delay IDE Initial (Secs): This item allows the BIOS to support some old or special IDE devices by prolonging this delay time. A larger value will give more delay time to the device for which to initialize and to prepare for activation. Full Screen LOGO Show: This item determines to show the full screen logo when booting. Disable unused PCI Clock: This option disables the clock of PCI slot that is not in use. [Enabled]: The system automatically detect the unused PCI slots, and stop sending clock signal to these unused PCI slots. NOTE: Set this option to [Disabled] setting if there are adapters that cannot be automatically detected by the system and will cause malfunction. User's Manual 3-10 Chapter 3 3-4. Advanced Chipset Features DRAM Configuration: Click <Enter> key to enter its submenu: Current FSB Frequency: This item will show you the current system front side bus speed. Current DRAM Frequency: This item will show you the current DRAM bus speed. When set to "By SPD", the BIOS will read the DRAM module SPD data and automatically set to the values stored in it. The system may be unstable or unable to boot up if your DRAM module does not support the clock you set. When set to [By SPD], the BIOS will read the DRAM module SPD data and automatically set the DRAM clock by the value stored in it. KV8-MAX3 BIOS Setup 3-11 DRAM ECC Mode: When set to [ECC], your DRAM module will support the ECC Mode. [. . . ] After all, your reseller regards you as an important customer who may purchase more products and who can urge your friends to buy from him or her as well. They should know best what your system configuration is and your problem. If you feel that you need to contact ABIT directly you can send email to the ABIT technical support department. First, please contact the support team for the branch office closest to you. [. . . ]