User manual 3M S15I INSTRUCTIONS MANUAL

[. . . ] - Use a grounded extension cord with a rating at least equal to that of the projector. To reduce the risk associated with hazardous voltage, impact, tripping, and intense visible light: - Do not use this projector around unsupervised children. To reduce the risk associated with hot surface of lamp cartridge: - Unplug the projector from the electrical outlet and allow the lamp to cool for 45 minutes before replacing the lamp. To reduce the risk associated with a ruptured lamp: - Always handle the fragile lamp module with care. [. . . ] To prevent damaging the projector, always hold the projector whenever using the elevator buttons to adjust the elevator feet. Use the accessory cable or a designated-type cable for the connection. For cables that have a core only at one end, connect the core to the projector. Incorrect connection may result in malfunction and/or damage to the device and/or projector. Do not place the projector in the side/front/rear-up position, except care of the air 8. 15. 8 3MTM Multimedia Projector S15i Product Safety Guide © 3M 2006 © 3M 2006 3MTM Multimedia Projector S15i Product Safety Guide 9 ENGLISH Product Safety Labels ENGLISH Lamp Lamp Operation: The following symptoms may indicate a lamp in need of replacement: · LAMP indicator lights up red. WARNING · To reduce the risk associated with environmental contamination due to mercury in the projection lamp: - Dispose of lamp cartridge in accordance with applicable federal, state and local regulations. Dispose of projection lamp in a manner that is consistent with your local hazardous waste regulations for mercury. - For recycling and disposal information, contact your respective governmental agencies. In U. S. , contact the Electronic Industries Alliance at www. lamprecycle. org In Canada, contact the Electronic Product Stewardship Canada at www. epsc. ca Display Lamp Operation Hours To determine the lamp operation hours, follow these steps: 1. While the projector is running, press the MENU button on the remote control. Choose the "OPTION" using the button, and press the button or the ENTER button. The lamp time is the time counted after the last resetting. Note Please reset the lamp time only when you have replaced the lamp, for a suitable indication about the lamp. Reset Lamp Hours (1) Press the MENU button to display a menu. Only when the EASY MENU has appeared, please perform the next step (2). appear. time. 10 3MTM Multimedia Projector S15i Product Safety Guide © 3M 2006 The glass lamp used in this projector contains small amounts of mercury and operates at high pressure and at high temperature and may unexpectedly shatter. Each lamp has a different lifetime and can fail in different ways, including a rupture with a loud bang or simply burn out. In the event of a lamp rupture, be sure to follow the instructions. WARNING · To reduce the risk associated with exposure to hazardous voltage: - Disconnect power cord when the projector is not in use, during lamp replacement, and while cleaning. - Do not attempt to service the projector - there are no user serviceable parts, other than the lamp cartridge, inside the projector. To reduce the risk associated with hot surface of lamp cartridge: - Unplug the projector from the electrical outlet and allow the lamp to cool for 45 minutes before replacing the lamp. To reduce the risk associated with a ruptured lamp: - Always handle the fragile lamp module with care. - Remove the projector from the ceiling or wall mount before replacing the lamp. In the case of a lamp rupture, small glass particles could fall out when the lamp door is opened or the projector is tilted. - Use care when replacing the lamp module in the event of a lamp rupture - small glass particles and small amounts of mercury may be present. [. . . ] Apple Macintosh and Apple Powerbook are registered trademarks of Apple Computer, Inc. Microsoft and Windows 95 & Windows 98 are registered trademarks, and Windows and Windows for Workgroups are trademarks of the Microsoft Corporation. All other products are trademarks or registered trademarks of their respective companies. © 3M 2006 3MTM Multimedia Projector S15i Product Safety Guide 13 ENGLISH Warranty Important Notice All statements, technical information, and recommendations related to 3M's products are based on information believed to be eliable, but the accuracy or completeness is not guaranteed. Before using this product, you must evaluate it and determine if it is suitable for your intended application. [. . . ]