User manual 3M BONDING FILMS

[. . . ] Bonding Films Products and Specifications Strength, cure rate and heat resistance characteristics of 3M Bonding Films. TM Relative Strength* Overlap Shear Strength (psi) 5500 4000 2500 TBF406 900 TBF695 700 TBF557 500 300 TBF669 100 0 TBF560 5 10 15 20 80 583 TBF620EG TBF668 TBF615 TBF845 AF111 Bond/Cure Time 1 hr AF42 60 sec 588 2-5 sec ThermoplasticNitrile Based Films Phenolic Films Epoxy-Based Films 180° Peel Strength (plw) *Check chart for substrates used in measuring strength. 2 Lb. [. . . ] Given the variety of factors that can affect the use and performance of a 3M product, some of which are uniquely within the user's knowledge and control, it is essential that the user evaluate the 3M product to determine whether it is fit for a particular purpose and suitable for the user's method of application. Limitation of Remedies and Liability: If the 3M product is proved to be defective, THE EXCLUSIVE REMEDY, AT 3M'S OPTION, SHALL BE TO REFUND THE PURCHASE PRICE OF OR TO REPAIR OR REPLACE THE DEFECTIVE 3M PRODUCT. 3M shall not otherwise be liable for loss or damages, whether direct, indirect, special, incidental, or consequential, regardless of the legal theory asserted, including negligence, warranty, or strict liability. Adhesives Division 3M Center, Building 220-8E-05 St. 1-800-362-3550 3M. com/eAdhesives 10% Post-Consumer Waste Fiber Total recovered fiber All post-consumer fiber Printed in U. S. A. © 3M 1999 78-6900-9766-8 3M Bonding Films have performance profiles for the most demanding applications. 3M Bonding Film Specifications TM Product TBF406 Base Resin EAA Color clear Standard Thickness* (mils) 3 Bond/Cure Time 2-5 sec Bondline Temp. (°F/°C) 320/160 Approximate Percent Elongation 750 Overlap Shear Strength (psi) 2500 on al 180° Peel Strength (piw) 3. 4 on ss 2 Lb. Deadload Heat Resistance (°F/°C) 200/93 Release Liner none Key Characteristics Good adhesion to metal. Clear. TBF557 EVA translucent 4 2-5 sec 275/135 500 600 on al 3. 6 on al 140/60 paper Good adhesion to plastics & metal. TBF560 EVA clear 4 2-5 sec 180/82 175 260 on al 5 on al 140/60 paper Low bonding temperature. [. . . ] Cures at 350° . TBF845 Polyolefin translucent 4 2-5 sec 270/132 850 750 on crs 21 on crs 160/71 paper AF111 Epoxy white 10 1 hr 250/121 2 4000 on al 10 on al >400/204 paper AF42 Epoxy translucent 3 1 hr 350/177 2 5500 on al 80 on al >400/204 paper 583 Nitrile Phenolic brown 2 60 sec 350/177 600 550 on al 12 on al >300/149 paper Heat or solvent activated. 588 Nitrile Phenolic yellow 6 60 sec 350/177 100 500 on al 12 on al >300/149 paper Heat activatable only. *Custom thickness available up to 40 mils [. . . ]