User manual 3M 3M-MATIC CTS CONTINUOUS TAPING SYSTEM

[. . . ] VGA and XGA are trademarks of International Business Machines Corporation. S-VGA is a registered trademark of the Video Electronics Standards Association. No publication or commercial use may be made of this material without the express written permission of 3M. Safety Information Please read, understand, and follow all safety information contained in these instructions prior to the use of this projector. Retain these instructions for future reference. Explanation of Signal Word Consequences m Warning: Indicates a potentially hazardous situation, which, if not avoided, could result in death or serious injury and/or property damage. [. . . ] Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel brouilleur du Canada. © 2008 3M. All Rights Reserved. 5 Operator's Guide 3MTM Micro Professional Projector MPro110 INSTRUCTIONS TO USERS: This equipment complies with the requirements of FCC equipment provided that the following conditions are met. The cables may have to be used with the core set to the projector side. Note: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. CE Statement ElectroMagnectic Compatibility Statement: Meets 2004/108/EC Directive Low Voltage Directive: Meets 2006-95-EC Directive. WEEE Statement The following information is only for EU-members States: The mark shown to the right is in compliance with Waste Electrical and Electronic Equipment Directive 2002/96/EC (WEEE). The mark indicates the requirement NOT to dispose the equipment as unsorted municipal waste, but use the return and collection systems according to local law. RoHS Statement 3M Projection Systems can provide RoHS certification for products meeting the RoHS directive. 1 European (EU) Restriction of Hazardous Substances (RoHS) Directive, 2002/95/EC, RoHS compliant means that the product or part does not contain any of the substances in excess of the following maximum concentration values in any homogeneous material, unless the substance is in an application that is exempt under RoHS, as amended:(a) 0. 1% (by weight) for lead, mercury, hexavalent chromium, polybrominated biphenyls or polybrominated diphenyl ethers; or (b) 0. 01% (by weight) for cadmium. This information represents 3M's knowledge and belief, which may be based on information provided by third party suppliers to 3M. 1 6 © 2008 3M. All Rights Reserved. Operator's Guide 3MTM Micro Professional Projector MPro110 Package Contents 1 2 3 4 5 6 Projector Battery Charger/AC Adapter Video Cable VGA Cable Battery RCA Adapter 3 4 1 2 Note: In some regions, the battery charger/AC adapter will come with an outlet adapter. 5 6 Parts 1 2 3 4 5 6 7 Focus Wheel Lens Power On/Off Video IN VGA IN Power and Charge LEDs DC Power IN 1 3 2 6 45 7 © 2008 3M. All Rights Reserved. 7 Operator's Guide 3MTM Micro Professional Projector MPro110 Getting Started Install Battery The 3M MPro110 comes with a rechargeable Lithium-Ion (Li-Ion) battery. The battery should be charged before using the projector with the battery. If the dust is difficult to remove, dampen the cloth with clean water and then wipe the projector clean. Then use a clean cloth to dry the projector. Important Notes · Do not use cleaning chemicals or solvents to clean the projector. Cleaning chemicals and solvents may cause the plastic parts to discolor. 12 © 2008 3M. All Rights Reserved. Operator's Guide 3MTM Micro Professional Projector MPro110 Troubleshooting Problem Image is fuzzy Cause Projector-to-screen distance outside of limits. LED is orange during charging and goes off when battery is fully charged. Connect input cable and power on input source. Does not run on battery power Blank image Power is off. Battery is low. LED flashing red LED is green LED is orange Projector in Power Saver Mode. Battery is charging. Video or VGA icon is flashing Video/VGA icons alternate flashing No input signal is detected by projector. All Rights Reserved. 13 Operator's Guide 3MTM Micro Professional Projector MPro110 Specifications Projector Description Imager Technology Size Image Resolution Image Aspect Ratio Projection Distance Image Size Throw Ratio (Width/Distance) Lens Offset Inputs Compatible Resolution Refresh Rates Video Compatibility Dimensions Weight Tripod Socket Operating Temperature Altitude Specification LCOS 11. 9 mm (0. 47") 640 x 480 Pixels 4:3 305­1800 mm (12"­70") 163­975 mm (6. 4"­38. 4") 0. 53 1:1 (none) VGA, Composite Video, DC Power VGA, SVGA, XGA 60 Hz NTSC, PAL, NTSC (M), PAL (BGHI) 115 mm (L) x 50 mm (W) x 22 mm (H) (4 1/2" x 1 31/32" x 7/8") 160 g (5. 6 oz. ) ¼"-20 10°­30°C (50°­86°F) Sea Level to 1, 829 m (6000') 14 © 2008 3M. In the case of an approved warranty claim, the replacement 3M product will carry only the remaining term of the original 3M product's warranty period as stated above. For warranty service, you must provide proof of the date of the original purchase else the manufacturing code date will be used to establish the start date of the warranty. [. . . ] This limitation applies regardless of the legal theory upon which damages are sought. For warranty support, please call or write your local 3M office or a 3M Authorized Service Provider to obtain an RMA # (Return Material Authorization number) before returning the product. If you are inside the Continental United States of America, please contact 3M Customer Service at 1-866-631-1656 or email meetings@mmm. com. What 3M Will Do To Correct Problems: · If your 3M product requires service, 3M will ask you to bring or send the 3M product, securely packaged in its original container or equivalent, along with proof of the date of original purchase, to your 3M Service Dealer or 3M Service Center. [. . . ]